Question about 2007 Nissan Xterra Off Road

Open Question

Service Engine light with gas gauge not working.

Posted by bcrewe12 on

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The service engine soon light came on and at the same time the gas gauge stopped working. Why?


SEL is probably on because you don't have gas cap on correctly, or gasket on cap is torn. Gauge not working is separate issue I expect. Could be fuse, bad gauge, bad sending unit inside tank, or broken wire.

Jun 12, 2015 | 2005 Ford Explorer

1 Answer

Gas gauge not working and now engine light came on


Best check the code you need OBDII code reader.

Apr 10, 2013 | 2002 Ford Escape

1 Answer

Gauges in car quit and now car dies when you take your foot off the gas in a 1992 buick regal


I would suggest having sensors checked......and fuses and relays...

Aug 19, 2012 | 1992 Buick Regal

1 Answer

2000 gmc sierra 1500 for last month check engine light stays on - previously, for several months, the fuel gauge would (still does some) not work when started up (whether warm or cold) until I put it back...


have vehicle scanned most auto stores offer this service for free the trouble code will give u a start point towards correcting that problem as to the gauge sounds like a different problem from check engine possible connected but doubt it check the wiring up under dash around back of gauge for loose or damaged wire[s] if wires good use a meter and test gauge itself for possible short

Jan 28, 2011 | GMC Sierra 1500 Cars & Trucks

1 Answer

Hi, The gas gauge is not working. Local mechanic tells me the module for the gas gauge needs to be replaced. Will not replacing the gas gauge module, keep the 'service...


Hello, the gas gage problem is caused by a defective gas gage sending unit, the sending unit is only sold as the entire Assembly which is called the fuel pump module, that said the gas gage problem is not related to the check/service engine light issue, that is an indication of a problem in the electronic engine control system or emission control system, when this light is on a fault code is put into the memory of the computer called the PCM, to retrieve this code requires a test be run called the OBD2 fault code test, this is done through the diagnostic connector that is in front of the steering wheel and under the dash, a code reader is needed, you can also get the code read for free by most discount auto parts stores like Kragen or Autozone.

Nov 17, 2010 | 1998 Jeep Grand Cherokee

2 Answers

My service engine soon light came on and my gas gage dropped below empty and gas light came on. I stopped and filled up and the gas light stayed on for another 50 miles. The service engine light is still...


It would be nice to know why the service engine light came on and is still on. An auto mechanic can read the code for you, or a dealer, or some parts stores will sell a device to read the code that caused the light to come on.

Dec 23, 2017 | 2007 Nissan Frontier SE Crew Cab

1 Answer

My 1994 Mercedes c220's fuel gauge stopped working


Fuel level sensor is in the gas tank, may be faulty or just dirty, make sure to fill the tank entirely full with premium unleaded, ad a high quality fuel system cleaner / de-gunker, this may clean the sensor enough to feed back to the gauge. It could also be the fuel gauge itself, but that is less likely. Mercedes will be happier with at least 1/4 tank of fuel at all times, and don't skimp on low octane gas!
As for the check engine light, you may have a bad gas cap... believe it or not a gas cap that doesn't seal properly will throw the check engine light. If you get the codes read (for free) at an Autozone or similar parts store it will likely read "evap system" as the problem, which will likely end up being the gas cap.
Take your car to a service center that does a true "flush and fill" of your a/c system. Those little canisters will just waste your money, and they never truly clean and re-lubricate the system like a flush and fill will do.

May 30, 2010 | 1994 Mercedes-Benz C-Class

1 Answer

When I fill up my 2007 Pathfinder the gas gauge show zero gas, light on and the check engine light comes on. As I run the gas gauge will show the correct amount of gas and later the engine light will go...


The fuel level sensor is at fault and is setting the service engine soon light on. Your local Nissan dealer can repair this under warranty depending on your mileage. The fuel tank will need to be removed to access the sending unit.

Mar 01, 2010 | 2007 Nissan Pathfinder Off Road

1 Answer

I have a 1999 Jaguar XJ8, there is a Check Engine


the gas gauge is not related, that would be a defective gas gauge sending unit in the gas tank, the check engine light indicates that one of around 200 poss faults has occured in the electronic engine controls, you will need to have the OBD 2 engine control system tested for the fualt code that is stored when the light is turned on.

Sep 10, 2009 | 1999 Jaguar XJ

1 Answer

Fuel gauge not working


Normally I'd say the float/sending unit in the gas tank is the culprit, however the fact that your service engine light is involved requires further investigation, You need to hook up an obd2 reader to the interface mounted under your dashboard and see what it has to say, there might be a simple error code preventing your gauge from functioning. Many auto parts stores will do this for you for free...

Apr 13, 2009 | 2006 Ford F-150

Not finding what you are looking for?
2007 Nissan Xterra Off Road Logo

Related Topics:

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14852 Answers

Vincent G
Vincent G

Level 3 Expert

2363 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...