How do I change the Q7 rear brake light bulb?

change bulb

the light is burnt or socket damaged or even a fuse could be burnt does it work with the parking lights on and does the flasher flash faster then before when it worked just change the bulb

On this website, you find fuse box diagram and description for Audi Q7 (2005 - 2015)


Audi Q7 2005 2015 fuse box diagram Auto Genius

you need to replace the pad wear sensor when the pad wears down it wears the sensor and the sensor needs to be replace if you look at the sensor you can see the wire on the sensor wears threw

there is an access cover in the trunk.Open that and just pull the bulb fixture out replace the bulb and place back in the hole.

check and change switch down on brake padel

Does the brake light in the rear window work? If so, the brake light switch is good. Running lights all work?

Removing:

• Switch off all electrical consumers, switch off ignition key and remove ignition key.
• Remove rear luggage compartment side panel trim (left or right).

• Remove 3 nuts, arrows, and remove housing.
• Remove bulb holder.

Installing:

• Install bulb holder.
• Insert housing into body opening.
• Tighten nuts.
• Install applicable rear luggage compartment side panel trim.

Rear Light Bulb Holder Removing And Installing:
Removing:

• Disconnect electrical connector.
• Depress retainers, arrows, and remove bulb holder.

Installing:

• Install in reverse order of removal.

And the Center Mounted Brake Lamp.
High mount Brake Light Removing And Installing:
The high mount brake light is installed in the rear shelf.
Removing:

• Switch off all electrical consumers, switch off ignition key and remove ignition key.
• Disconnect electrical connector from high mount brake light.
• Remove rear shelf
• Un-clip high-mount brake light from rear shelf, arrows.
• Install in reverse order of removal.

NOTE: The bulb holder base plate contains soldered- in light emitting diodes (LEDs) that are not replaceable. In the event of LED malfunction, replace complete bulb holder.
Additional

unscrew the case from around the light pull the case off and then youll have access to the bulb take the bulb out usually turns counter clockwise replace with new one reverse the process.

they may be dual element bulbs. the element used for the tail lights is ok but the brake light element is burnt. change both bulbs.