Question about 2005 Nissan Altima

1 Answer

03 altima PO335 code, replced sensor still starts hard

03 altima PO335

Posted by ronieathome on

Ad

1 Answer

kevingsuzuki

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Nissan Master
  • 752 Answers

Cranshaft Position Sensor A Circuit Malfunction.did you reset your compter when sensor was replaced

Posted on Feb 05, 2010

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

03 Durango 4.7,I'm getting PO129,PO300,and PO335 codes .engine isn't idling rough after initial start hard starting.Vacuum is at 20 in and holds steady. Codes all hit at same time with 50 psi fuel


p0129 refers to BAROmetric pressure---too low ==causes --wiring --BARO sensor--mechanical fault
code p 300 is random misfires==causes injector /s fuel pressure --coil/s plug/s--low compressionwiring
P0335 refers to crankshaft position CKP) sensor---circuit malfunction===causes --wiring--CKP sensor ECM
the clue here is the very high vacuum reading indication an air flow blockage from the filter to the engine
vacuum at idle sits around the 15 mark and 20 on deceleration from high rpm where the throttle butterfly shuts of the air intake
It only last until idle rpm is reached

Sep 22, 2018 | Cars & Trucks

1 Answer

Why won't my nissan altima not start?


reach down under the master cylnder with 10 mm socket on 6in ext to replace crank sensor for code po335 crank no start

Jul 13, 2014 | 2005 Nissan Altima

1 Answer

Nissan Altima 2.5, service engine light on car is hard to start


you need to hook up a scan tool to see what fault is causing check engine light.i would be willing to bet you will get a po335 crank sensor or po 340 cam sensor.high failure rate on these vehicles.

Jan 31, 2011 | 2005 Nissan Altima

1 Answer

Codes


PO725 = Engine Speed Input Circuit
PO335= Crankshaft Position Sensor A Circuit

Apr 19, 2010 | 2002 Nissan Altima

1 Answer

Service Engine Light On


It has to do with the cps, crankshaft position sensor. Take it to Autozone and ask them to pull the codes to verify them. They will then sell you, if you want it, the correct part - this service is free at autozone!!

Apr 19, 2010 | 2002 Nissan Altima

1 Answer

Throwed a code po335 crank sensor , i changed the crank sensor cleared the codes and 30 miles later check engine light came back on


Are you sure it was the crank sensor that you replaced? The cam and crank sensors look identical. Was the engine hard or slow to start? If so, this will sometimes set this code.

Nov 09, 2009 | 2006 Nissan Altima

2 Answers

Trouble codes PO725 and PO335, car jerks hard during steady speeds on highway intermitently I am told the speed sensor by local parts stores and a revolution sensor by my local dealer. I am not sure which...


Nissan has reproduced the crank sensors installed in all altimas 2004 and up. it was deffective. Its also sort of difficult to access. take off the intake tube, dissconnect the throttle body connector. and reach to the bottom of the engine right next to the motor mount.take the connector off and see if the feel for oil. There will most likely be oil on the connector. Replace sensor

Sep 16, 2009 | 2005 Nissan Altima

1 Answer

Nissan 2.5 repair code po335-po725 car shot off while runing


FIRST THE P0335 CODE IS A CODE FOR LOSS OF CRANK SENSOR SIGNAL... MOST OF THE TIME YOU NEE TO REPLACE THE CRANK SENSOR... NEXT THE CODE P0775 IS FOR A PRESSURE SENSOR CODE FOR TRANNY... ERASE THAT CODE AND JUST SEE IF IT RETURNS...NOT A BIG DEAL ON THAT ONE

Sep 01, 2009 | 2003 Nissan Altima

1 Answer

OBD malfunction indicator light status on stored diagnostic trouble codes po325, po335, p1336 . Car will not pass OBD test.


CODE PO325 - KNOCK SENSOR. CODE PO335 -CRANK SHAFT POSITION SENSOR. CODE PO336 - I DID NOT SEE CODE PO336.

Aug 28, 2009 | 1997 Nissan.5 Altima

Not finding what you are looking for?
2005 Nissan Altima Logo

Related Topics:

690 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...