2001 Volvo C70 Logo

Related Topics:

Question about 2001 Volvo C70

1 Answer

My 2001 C70 2L LPT is not starting very time, when it doesn't start it turns over but doesn't fire up, when this happens just the motion of opening and closing the bonnet gets it to start. Does anyone have any suggestions please? Also, does anyone know where you can get a workshop manual for this year and model? Thank you.

Posted by bay72 on

Check Price eBay

1 Answer

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 3 Answers

Hi,

Sounds to me like defected antitheft switch for engine bay/bonnet.

bregs.
nonno229

Posted on Apr 10, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Engine cranks tries to start but doesn't

CAR NO START PROBLEMS:-----


It can be the issue with weak battery or faulty battery or if battery is ok,then its faulty starter causing the issue.


From start to end troubleshooting these problem i suggest you to click the link below and follow its procedure:-----



What to Do When Car Turns Over But Won't Start?

http://technoanswers.blogspot.com/2012/11/what-to-do-when-car-turns-over-but-wont.html


-----------
Car starting issues?

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

------------
Car Starting Problems

http://whoisbyme.blogspot.in/2012/06/car-starting-problems.html


--------
1991 Toyota Trecel: Engine Starts fine but dies when gets Warm?

http://whatisbyme.blogspot.in/2012/05/1991-toyota-trecel-engine-starts-fine.html

----------
1994 Toyota Pickup: Starts fine but dies in few seconds?

http://howtobyme.blogspot.in/2012/05/1994-toyota-pickup-starts-fine-but-dies.html


---------
1999 Chrysler Cirrus: 8 IGN Fuel Starter Fuse Blows?

http://whatisbyme.blogspot.in/2012/06/1999-chrysler-cirrus-8-ign-fuel-starter.html


-----------
2001 Toyota Camry: No start After replacing Battery?

http://whatisbyme.blogspot.in/2012/05/2001-toyota-camry-no-start-after.html

----------
1989 Toyota Pickup Truck: Turns over but not start? http://whatisbyme.blogspot.in/2012/05/1989-toyota-pickup-truck-turns-over-but.html

--------------
Car dead and will not Start? http://whatisbyme.blogspot.in/2012/05/car-dead-and-will-not-start.html

--------
1995 Lexus LS400: Running Hot?

http://whatisbyme.blogspot.in/2012/05/1995-lexus-ls400-running-hot.html


----------
2001 Toyota Prius will not start? http://whatisbyme.blogspot.in/2012/05/2001-toyota-prius-will-not-start.html

---------
1996 Jeep Grand Cherokee: Engine will not start? http://repairhelpcenter.blogspot.in/2012/06/1996-jeep-grand-cherokee-engine-will.html ------------- Mitsubishi will not start

http://www.howtorepairguide.com

---------

These will help.

Thanks.

0helpful
1answer

When I try to start the tracker it does not fire up, it turns over but doesn't start

1.out of gas
2. fuel filter and /or pump (lack of fuel)
3. coil module (no spark)
4. camshaft sensor
5. crankshaft sensor
6. timing belt or chains
1helpful
1answer

2001 jag stye turns over but won't start what could be the problem?

It could be as simple as a bad fuel pump or clogged fuel filter to something more in depth like a broken timing chain or bad sensors. Check the Fuses first to make sure they are all good then check the relays under the hood. If the fuses are good and the relays then spray some starting fluid into the air intake, If it fires then the problem is a fuel pump or filter if it doesn't you are going to have to test the Crank and cam position sensors to find the bad on and the coil pack.
0helpful
1answer

It starts fine but it misses when it is started we changed plugs n wires and egr valve. could it be the timing?

Check the firing order of the engine and make sure the plug wires are on correctly. Timing doesn't change when replacing plugs and wires. If the order is correct check to see if the wires are on the plugs correctly and not broken. Looking in a dark place you can see if there is a spare jumping from a defective wire.
0helpful
1answer

2001 ford taurus, 3.0 vulcan motor. just rebuilt the whole motor, backfires out of the intake, seems to be out of firing order. i triple checked my work and can't find the problem. whistling sound of...

Back firing out of the intake is because the valves/cams are not set right. When you did the timing belt . did you set the crankshaft mark at top dead center of the compression stroke. If it's at the exhaust stroke this would cause backfiring and violent shaking.
0helpful
1answer

Drove it home, evrything fine, went out 2 hours later, will not start, engine turns over but wont start, replaced the coil pack still wont start

Make sure that you have fire and fuel. You may want to spray some ether into the air intake. If it doesn't want to start and it has fire, you may want to consider the timing chain.
0helpful
1answer

2001 Toyota highlander(4cyl),turns over,won't start afer few spins.Then,it will finally start.Has always started(fired)immediately- pumped gas a couple of times and it will finally start-runs fine-any...

Your cold start valve is not opening to assist the firing. It function is to provide extra fuel to ignite the all combustion chambers easily. When the engine doesn't have this extra fuel from the cold start valve, it will take a few times to get it going. The cold start valve is turned on at the time of starting only if the ECM get the signal from coolant temperature sensor saying it is at a preset level. When the sensor is bad, it can give a wrong value so ECM think that temperature is hot so not turning the Cold start valve. Replace this coolant sensor first, then the next thing is to check out the cold start valve.
0helpful
2answers

I have a 2001 dodge grandcaravan 3.3 liter engine .the engine light came on so took it to autozone to have them read the error codes .they came up with failure of transaxle control module and pressure...

tcm is located in drivers side front wheelwell. will have to remove wheel and wheel well splash shield. unhook 60 pin connector and three screws holding tcm to vehicle. will have to set pinion factor and quick learn function via factory scan tool solenoid pacxk located below air cleaner on transmission facing front of vehicle
Not finding what you are looking for?

296 views

Ask a Question

Usually answered in minutes!

Top Volvo Experts

Marvin
Marvin

Level 3 Expert

85241 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22516 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15087 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...