Question about 1996 Chrysler Town & Country

3 Answers

I have a 93 dodge ram 250 with no spark. I have tested the coil and have the correct voltage at the cam sensor. Can you help?

Posted by Anonymous on

  • Anonymous Jan 27, 2010

    The crank sensor tests good, there is no module, only a cam sensor in the distributor. I tried replacing relays. the PCM shows no distributor reference signal....

×

Ad

3 Answers

Anonymous

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 141 Answers

Change the Powertrain Control Module. Had that same problem myself. No signal at the pcm for the coil.....checked the ASD, etc...... it finally came down to the PCM. But listen to the other 2 Tech's...go through the steps to be safe and not waste your money if I'm wrong on this. But, if you can afford to....then.......Hope this was helpful.
Bryon

Posted on Feb 05, 2010

Ad

Susan Price

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,857 Answers

So now you will need to test the crank sensor, the ignition module and the PCM. If you have a ASD relay in the underhood fuse block swap it with one of the others. This powers up the ignition system

Posted on Jan 27, 2010

Ad

Marvin

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chrysler Master
  • 85,239 Answers

What fault codes do u have in the memory of the powertrain control module? if you have not tested that yet do so, it is key to finding the failed part.

Posted on Jan 27, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2005 dodge neon that will crank but wont start. I have replaced the cam shaft sensor, crank sensor and the coil pack. Iam also not getting spark to the coil pack. Any suggestions?


Primary voltage to several systems, including the ignition coil, dark green wire with orange tracer. That voltage comes from asd relay. There is a fuse for asd relay. To check for voltage the engine has to cranking. The control side of asd relay, the computer has to ground it before it will energize. Did you check wiring circuits for cam and crank sensor connectors before replacing sensors? Are there any applicable trouble codes?
Are you ok with testing wiring circuits?

Feb 16, 2017 | 2005 Dodge Neon

2 Answers

Cranks but no spark


hi dean.
try this link it might help you find out why it will not start.
1997 dodge Avenger with 2 0 engine Cranks but no spark Google Search

Nov 02, 2017 | Dodge Avenger Cars & Trucks

1 Answer

1995 Dodge 2500 van no ignition


I have the same issue on a 94 B250 - replaced ECM, cam and crank sensors - still only coil primary with initial relay cycle, then nothing during crank. Was told ECM needs signal from cam and crank to send primary to coil. Very confusing - all wires connected.

Sep 01, 2012 | 1995 Dodge Ram 2500

1 Answer

Have a 94 Dodge. Ram 250 van with no spark replaced plugs wires distributer cap and button also fuel pump still nothing.


Why would you replace the fuel pump because your engine has no spark??? - Just asking....diagnosis by parts replacement is the EXPENSIVE way to do it.

Anyway, have you checked for ignition voltage at the coil? Did you check to see if there was spark at the coil?

Apr 19, 2012 | 1993 Dodge Ram 250

2 Answers

1999 Dodge Ram 1500 318 engine no spark no signal to coil i changed cam positioner sensor and crank positioner sensor still no spark could it be a bad wire (ground)somewere


Check the ASD relay in the fuse box. Swap it with the starting relay. If the engine fails to roll over. Thats your problem. If not, check and see if your fuel injector connectors have voltage to them if not its a bad PCM. Hope this helps.

Jun 05, 2010 | 2000 Dodge Ram 1500 Truck

1 Answer

No fire, Won't Start


immobilizer , crank and cam position sensors have not being mentioned
dodge code 32 refers to faulty EGR and not to ignition problems
also if the ignition switch is faulty there will be no run circuit to provide power for the ignition in the run position

Nov 14, 2017 | 1995 Dodge Ram

1 Answer

1997 Dodge Ram 1500 5.2 liter won't start


I WOULD SAY IT IS THE COMPUTER {BRAIN} THAT IS WHAT SENDS THE FIREING ORDER AND VOLTAGE AND SETS THE TIMEING SPECK I WOULD SAY CHECK THE COMP

May 21, 2009 | 1997 Dodge Ram 1500 Club Cab

1 Answer

No spark


Check for signal from distrubutor as it acts as your igniter open and close switch or get a haynes manual from auto parts store to trouble shoot it multi meter required for ohm test and voltage drop test and test light. you may have power and ground but no signal. your igniter or incorrect gaps. Its a 20$ book with pictures....

Feb 27, 2009 | 1992 Dodge Ram 250

1 Answer

1996 1500 ram wont start


there is also a crank sensor that can keep it from sparking. are you getting voltage to the coil

Jan 03, 2009 | 1996 Dodge Ram 1500 Club Cab

1 Answer

1995 DODGE RAM B1500 NO START


You need to use a LED type test light for the injectors or a Bosch style Noid light for the injector. To test the cam/crank sensor signal you either need a scanner to read them or a lab scope to show you a signal. The pickup plate in the dist handles the injector timing, the crank sensor provides a RPM signal. They both feed the computer information for ignition timing. Good fuel pressure, injector activity(Noid), and good spark out of the coil. The coil is what I replace the most of.

Nov 19, 2008 | 1995 Dodge Ram

Not finding what you are looking for?
1996 Chrysler Town & Country Logo

171 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...