I am assuming you are referring to headlights due to the many people asking about Saab bulb changes.
Driver Side Headlight
1) Remove the battery cover to provide enough room to access the back of the light housing
2) Remove the two clips that hold down the windshield wash hose. (for more room)
3) Remove the rubber cover on the light housing
4) Disconnect wires, unclip the bulb, use a paper towel to install the new
bulb with square marker on the bottom. Try to avoid any finger prints and touching the bulb.
Passenger Side Headlight (takes about twice the time as drivers side
1) Disconnect the air intake
rubber hose and move it out of the way. To do this, two clamps need to
be loosened. Remove the end over the radiator first, then the other
end behind the light, comes off easily. You do not need to disconnect the
sensor/filter. The hose is supported with an aluminum arm that can also be
disconnected. (on installation, make sure to line up the slots on the
filter/sensor to the hose)
2) Now there is clear access to the light housing. Very tight though.
3) See step 4 above
4)When re-assembling the hose, connect the end behind the light first then
the end just above the rad (bit easier). There are slots on
the hose that line up with the sensor/filter. Reconnnect the aluminum
hose support (if you removed) and then you're finished.
Hope this helps
×