3 buttons on the underside of my 2001 sebring visor

usually u here it clanking around a little like when you turn it make a clanking noise usually

Thanks for choosing FixYa and welcome. The code, as you already know, is the #3 misfire. You may have an issue with the idle control sensor or map sensor. Did you change the wires also?

Some of these dont use a light you just hit the on button and set cruise remember if brake is hit it shuts down and you must be going over 40mph, if this doesnt work then check your fuses,good luck.

probably have a bad ground to the dash cluster or the dimmer is shorted

Reinstall your own code,if the preset works and you still have the little instruction card. If not let me know,I'll look at mine and go over the service manuals

i guess u have standard radio that came with the car? i don't know how it calls this thing, but when u turn on ur headlight, on the same stick there is another regulator that regulates light in the cabin and dash light, so turn it off, turn clockwise! or leave a little light in ur dashboard!

There should be latches you have to pull first to unlock the top from the windshield. Pull down the sun visors, the handles should be under them. Then push the power top switch.

go on the opner motor press the learn button until it blinks then press the remote button within 20 seconds it should work after that

What the last guy post is correct, but you have to tel your car what kinda remote you have. Assuming you have homelink Which 95 percent of the cars do ill give you a very short version on how to do this. First thing you need to do is clear the code in your car from any other owners. Do do this turn your car's key to the on or acc non running position. Press and hold the first and last button. Untill the light reacts different ether starts flashing or flashes faster etc. Then you need to get one of your remotes. Press and hold the button you want to set in your car and press your remote button at the same time untill the light reacts diferent. Mind you hold your garage remote as close to your car remote as you can. Then finally Find your learn button on your garage door opener it's self it can be in the back or the front if its in the front you have to remove the cover press the button once DO NOT HOLD IT. then go to your car and press the button you set for about 2 seconds and repet 1-2 more times untill your garage door moves. Make sure nothing is in the way of the garage door. (I know that should go with out saying.)

GOTO HOMELINK.COM

THEY MAKE THE SYSTEM AND HAVE INSTRUCTIONS YOU CAN DOWNLOAD.

PLEASE NOTE: MOST BUT NOT ALL BRANDS/MODELS OF OPENER WILL WORK WITH THIS SYSTEM.

HOPE THIS HELPS