- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hi. I read your inquiry but I'm unsure of what your asking. The brake lines don't go straight to the brakes. What are you asking about "two upper and two lower"? These lines can not be confused. From the master, the two supply lines run to the ABS module. From the ABS module four different lines run out to each wheel. If your interested. eBay sells a complete pre-bent brake line kit. eBay Product Number: 3015274614 You could also call your local part store for availability or if you have the tools. You can save the money and bend them. I hope this helps. Please write back if you have any other information. Good Luck.
If you have drums on the rer yes you do have to remove the axle its simple though you unbolt the 6-8 bolts on the end of the axle then it just simply slides out thats it there mite be some resistance but there isnt anything else holding it in. and you dont have to worry about putting it back into the same spot eather just slide it back in and line up the drum.
Pads and rotors are easy. You will have to take the tire off. There will be two bolts on the back side of the calipers. You will need a large allen wrench to remove them. Once you get the calipers loose, you can swap out the pads. The rotors will slid off the axle itself without having to take anything else loose. When you put the calipers back in place, tighten the bolts you removed. After you get everything put back together, make sure you pump your brakes till they get tight BEFORE and AFTER you start your vehicle. You need to test your brakes out before you drive off. The bolts are self tightening.
Door mirrors on chevrolets tend to be model and year specific. the auto recycler can tell you for sure since most carry a book which shows what parts will interchange with what car.
Solder and shrink tubing work fine for that. That is for the pk2 theft module that tells the car that you are using the correct key with the chip in it.
Compare the setup with the way they are arranged on the opposite wheel. I always recommend doing one wheel at a time with drum brakes, that way you can always walk to the other side and see how the springs are arranged.
×