Question about 1996 Honda Accord

1 Answer

Where is the shifter linkage located on a 1996 honda accord auto

Posted by arsjoquist on

Ad

1 Answer

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Look on top of the transmission It should be cable operated

Posted on Jan 04, 2010

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

My 1996 Honda accord will not easily shift into 3rd and 5th gear ONLY SOMETIMES when it doesn't I have to try about 2-3 times before it will go into gear eventually


There could only be a couple possibilities for this to happen. First, with standard shift transmissions the shifter linkage could be worn being that it only happens with 3rd and 5th gears, as this shifter slide works for both of these gears. If this is the case it is only a matter of visually inspecting the linkage for worn or broken parts and replacing them or adjusting the linkage which is the inexpensive fix that I hope you are looking at. Second, This could be caused by the syncronizers within the transmission are going bad/worn or broken. In either case the transmission will need to be removed and repaired or replaced which is the expensive route that I pray is not the way you have to go! I hope that this is some help.

Dec 03, 2014 | 1996 Honda Accord

1 Answer

Diagram on timing location of camshaft and crankshaft on a 1996 Honda Accord 2.7 V6


wow posted the engine, a rare post , thanks !
luck for your civics and accords have tons of free info.
in fact the FSM
enjoy
its all there. im sure.
http://hondatech.info/downloads/Auto/Manuals/Accord/

Nov 24, 2013 | 1996 Honda Accord

1 Answer

My shifter on my 2001 honda accord wont shift just moves back and forth wont go into gear


Either the linkage to the tranny from the shifter is broke or apart, or the internal linkage is broken. can you check the underside of the car and see if the linkage between the shifter and tranny are intact? Have someone move the shifter whil your looking at the linkage, this will tell you whethr it is internal or external.

Mar 15, 2011 | 2001 Honda Accord

1 Answer

Is the wiper motor linkage a seperate part from


The motor and linkage should be separate parts.

Feb 10, 2010 | 1996 Honda Accord

2 Answers

1992 Honda Accord Station Wagon stuck in 2nd Gear


your linkage from the shifter to the transmission is out of ajustment, just tightin it up or loosin it witch ever it needs

Jan 25, 2010 | 1992 Honda Accord

1 Answer

Where isthe range sensor for 1997 honda accord


i'm sorry i'm not familiar with your vehicle, but a general answer would be either on your shifter assembly, which you'd have to remove the center console trim to access, OR on your transmission near the shifter linkage.

Dec 21, 2009 | 1997 Honda Accord

1 Answer

98 honda civic auto transmission shifter


I'm thinking this is an interior problem. Dirt ETC.. can build up around the shifter, you can pop the panel below the shifter up with a screwdriver. Clean this panel up and lube up the linkage below and you should be good to go.
















May 23, 2009 | 1996 Honda Civic

1 Answer

91 Honda Acc Auto gear box is stiff


This is most ofthe related to lubrication of the cable, end bushings, and linkage at the tranny... especially at this age

You may want to disconnect the cable underhood and see if the floor shifter is mroe comfortable...

If the stiffness remains, I would suggest replacing the cable (lubrication is possible, but messy with the cable installed in the vehicle)

If your shifter move VERY freely, then likley the end bushing or linkage at the tranny - simple "maintenance" cleaning and lubrication should get you there.

IF the shifter at the tranny does NOT improve with external ceaning and lube, you may wish to flush/change your tranny fluid - many people do not perform regular changes and the position of the shifting bell-crank on the honda will allow dirt to accumulate and that shaft will bind as it passes through into the tranny.

May 14, 2009 | 1991 Honda Accord

1 Answer

Where do you check the fluid in the auto trans on a 96 golf gti


If you look right behind the battery in front of the trany near the linkage for the shifter you should see a small dip stick near the bottom of the trany its very hard to see do too its location.

Jan 02, 2009 | 1996 Volkswagen GTI

1 Answer

Auto transmission stuck in drive stick will move


It could be the linkage from the shifting lever to the tranns. This linkage isn't very expensive to have replaced and your shop can tell you if it is indeed the linkage or not.

Aug 13, 2008 | 1991 Honda Accord

Not finding what you are looking for?
1996 Honda Accord Logo

Related Topics:

199 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Vincent G
Vincent G

Level 3 Expert

2363 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...