Question about 2000 Nissan Xterra
Check to see if your latch is open unlock door put a screwdriver in the latch and open door with out side handel latsh will release
Posted on Jan 02, 2010
Had same problem on my 2000 Xterra last year. I found that the latch was not opening the whole way. Easy, free fix:
- remove first aid kit and pull ******** inside of rear door.
- use screwdriver top pry off plastic door panel (plastic push snaps will pop free as you pry).
- look inside door and lube/grease parts that move when you unlock door.
- you will notice the parts regain their full movement with some fresh lube.
- snap door panel back in place (wrap elec tape around plastic snaps if you need to make them fit tighter since they are a little weaker after being removed)
- good luck! you are now an expert!
Posted on Jan 13, 2010
SOURCE: outside door handle broke and child lock on
get a locksmith he or she should be able to open the door through the window.
Posted on Dec 14, 2008
SOURCE: 2002 Silverado outside Door Handle
yes. you should remove the inside door panel.
to do this, remove all the screws you can see. One in the door handle, one by the mirror, then remove window crank/buttons
the take a flathead screwdriver and CAREFULLY pry the panel off. it is best to pry where the plastic pins are holding the panel on.
reverse procedure to reinstall.
Posted on Apr 01, 2009
SOURCE: diver side door will not open with door handle (outsidedoor )
There is a small clip that holds the outside door handle arm (inside the door) to the latching assembly, so the door panel has to be removed to reattach it. Sometimes the little clip is still attached to the handle arm, sometimes they are in the bottom of the door & sometimes you can't find them at all... Rick
Posted on Apr 13, 2009
SOURCE: 2000 Subaru Forester drivers side outside door handle has jammed
take off inside door panel and check the linkage on the lock may be broken
Posted on Sep 16, 2009
Testimonial: "Thanks for that ... I'll give it a go. Cheers."
SOURCE: how do i remove door outside door handle on q7
On the inside trim, you can remove screws (these screws may be covered by filler pieces or may be visible, or they may require you pry a plastic piece off that covers the screws) that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can disconnect the linkage connecting to the outer handle and remove the bolts securing the outer handle on
Posted on Nov 05, 2009
Nov 09, 2017 | Cars & Trucks
Sep 30, 2016 | 2011 Hyundai Sonata SE
Jul 20, 2014 | 2006 Ford Focus
Jan 18, 2012 | 1996 Oldsmobile Bravada
Jun 15, 2010 | 1997 Mitsubishi Galant
Dec 25, 2009 | 1989 Ford Crown Victoria
Apr 13, 2009 | 1991 Chevrolet Lumina
Dec 14, 2008 | 2002 Hyundai Accent
Aug 15, 2008 | 1997 Oldsmobile Silhouette
203 people viewed this question
Usually answered in minutes!
×