Why can't i get a window regulator that is manually operated ?

There is a circuit breaker. They rarely go bad. If one window works it is good. If the drivers window is not working. It could be the window motor/regulator or the master switch, since this is the window that is worked the most.

2000 TOYOTA CELICA SERVICE REPAIR MANUAL DOWNLOAD

get your car fix right now

you will have to remove door panel to inspect the lower glass mounting frame to see if the rollers on window regulator frame are bad or lower glass mounting frame could be loose,or possible window regulator motor loose or motor woren out. hope this is helpful.

Hi there,

If manual window winder

Your driver's window glass may have come off the regulator mechanism.


If electric window control

The glass may have detached from the regulator or the regulator cable has unwound itself off the mechanism (ie tension during upward motion, but loose when motor stops winding).

Your driver's door panel will need to be removed to inspect your window regulator operation.

glass has gotten out of the window regulator track or a broken window regulator. have to remove door panel and now need to know if its power windows or hand rollup windows. if manual you will need to remove handle by removing c-clip from behind the handle.

You can pull the panel and move the window regulator manually to put the window back up. If you can get that far you may as well get the regulator from a boneyard an put it in. You will need a grinder to get the rivets out and some bolts to put it back in. If you don't change the regulator, make sure you unplug the motor inside the door because it may work in "down" mode but not up. You don't want to have to do it again. Or you could check Ebay for the regulator. Good luck.

Replace window regulator and motor. Procedure: Remove inside door panel, cut regulator wires, raise window manually and hold in place, undo bolts holding window glass to regulator, undo bolts holding regulator to door-frame, remove regulator. Reverse to install.

some times the window regulators on toyotas need to be resett if they get jammed or they are interupted when operating ... an easy way to reset the regulator in toyotas is to disconnect the passenger regulator or switch wait 5 minutes the reconnect and using the passenger switch hold it up for 20 seconds and then down all the way holding it down when it stops for another 20 seconds. then check that the drivers side is now working and reset

For like the third time today different people same problem. Did u check the lockout button on the left side of dash?

The 2" diameter white pulley is part of the regulator. That is what the cable rides on to raise & lower the window, and it is critical to the operation of the window. Replace the regulator assembly.