New model 99 Jetta. My sunroof was only sliding back on one side and part of the tilt arm was broken. I got a new sunroof assembly and pretty much have it installed, but the glass was in the wrong position for the screws, so I attached the motor and it would only tilt up and down. Not slide back, there is a little noise like the motor is trying to slide but then stops, what could be the problem? The chains look good, is there some other way to check them?
When you turn switch to the slide back position, do you hear the motor running ? If yes, might have a blocked or bad track. This will require you to remove trim covers and glass to have access to the track. Once all parts removed, turn the switch to open as you look at the motor and track move.
SOURCE: The sliding panel under my sunroof is broke. Any suggestions? The Sunroof motor is working.
The sunshade clips are probably broken. Need to remove the glass panel. Note the position of the panel the frt and the rear. If not properly reinstalled you might get wind noise. Once you have the panel removed unscrew the clips from the sunshade. Carefully remove the shade and install the new clips.
SOURCE: My 1990 Maxima's sunroof will slide up and shut,
Is there a way to manually close the sunroof in the up position on a 98 Nissan Maxima?
SOURCE: The sunroof on my 2006
Don't need an owners manual to push the button, to
actuate the sunroof
Maybe you have the owner manual with your
preventative maintenance log book ,where you
write down all you do on the car
If it won't operate correctly, you need a repair shop !!
209 views
Usually answered in minutes!
×