How to replace blend door actuator in a ford

mode door actuator inrear Hvac . The clicking is the actuator slipping it's gear's . Plastic gears break ,wear out etc....
You have to take right rear trim panel out to replace it >
2003 2006 Ford Expedition Rear HVAC Temperature Blend Actuator Clicking... Your having problem with the mode door actuator ,not temp blend door.

Temperature Blend Door Actuator - RH, EATC Removal and Installation

1. Remove the RH floor console finish panel.

1. Lower the glove compartment.

1. Disconnect the RH temperature blend door actuator electrical connector.
2. Remove the 3 RH temperature blend door actuator screws.
1. Remove the RH temperature blend door actuator.

2006 2010 Ford Explorer NO Heat Passenger Temp Actuator Replacement same as mountaineer

First, insure you do not have a vacuum leak or bad vacuum check valve. If this is all good, you may have to change actuator and every model has a different way to access this--some require dash removal. If you must do this, get a shop manual as the air bags CAN BE VERY DANGEROUS!

02 Ford Explorer Heat Blend Door Actuator Simple Fix - No ...

? 3:17
www.youtube.com/watch?v=uvuPzf0wjEg
Apr 28, 2012 - Uploaded by broomballusba12 02 Ford Explorer Heat Blend Door Actuator Simple Fix - No Tools Needed ... I will be making a few new videos shortly on the Ford Explorer, The Ford Expedition, .... This does Not Work on a 2002Ford Explorer Eddie Bauer.

There are electric motors that move blend doors in your dash board. The blend doors control the heat/cool ratios as well as the location the air will blow from. It's very common for the doors to break or the motor to fail and require replacement which can be costly.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/justin_3ae27a9d61d6acd4

2003 Ford Explorer Blend Door Actuator Repair
Not simple, tools required

Clicking sound is your blend door actuator stripping it's gears and failing to open the door that directs the blower air through the heater core. Follow the sound to the actuator and remove it. Install a new one. You may have to remove some panels to get to it. The part is shown below and costs $32 at autozone. Please let me know if you have questions.

yes, common problem. Blend door actuator is stripping it's gears. Remove actuator and make sure door rotates by hand. If not remove heater box and repair door operation. If it moves OK by hand, replace the actuator. I don't have procedures for replacing yours, but follow the sound, removing whatever panels necessary to get to it. The part looks like the below pic and sits flat on the heater box with a cable coming out of it. Cost is about $35. Let me know if you have any more questions.

The temperature blend door actuator is located on the right side of the transmission hump under the evap. case. The floor ducts cover it.