Question about 1991 Mazda RX-7

1 Answer

91 mazda rx-7 will not start - 1991 Mazda RX-7

Posted by andyg811 on

Ad

1 Answer

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

1990 MAZDA RX 7 WILL CRANK BUT WONT START JUST HAD TRANSMISSION REPLACED

Posted on Mar 25, 2010

Ad

5 Related Answers

Anonymous

  • 19 Answers

SOURCE: 87 mazda rx 7 n/a cutting out at 4000rpm

Sounds like plugged up pre cats, my NA had the same problem I got a Racing Beat header that eliminated the pre cats and it went away. I've also seen them on eBay for cheaper. Either way you can't lose the stock header is like a cast iron stove attached to the engine it's heavy and massive.

Posted on Feb 04, 2009

Ad
iadame

Israel Adame

  • 676 Answers

SOURCE: Changing front door speakers in 1990 Mazda RX-7

The size of speaker that will go into that vehicle is a 6 1/2". You will need to take off the door panel in order to remove speakers. Once door panel is removed, locate screws holding speakers and remove and reinstall new speakers.

Posted on May 05, 2009

Anonymous

  • 1 Answer

SOURCE: where is the starter located in the 1989 mazda rx-7

on the tranny

Posted on Jun 18, 2009

Anonymous

  • 16 Answers

SOURCE: problem with the 8 pack seal on a 1991 mazda rx 7.

I think that you might mean your APEX seal and in order to replace that you should probly just get the motor freshened up which isnt rebuilding it so it wont be so expensive.

Posted on Aug 08, 2009

Anonymous

  • 16 Answers

SOURCE: Fusbile Link-1983 Mazda RX-7

They are usually on the drivers side shock tower. And if you need them, and you want to buy them from me i have them,
Just let me know,
Robert

Posted on Jan 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the interior fuse box in my 1991 mazda rx 7


left side above clutch pedal, or left foot if automatic. Shown in owners manual exactly.

Jan 01, 2013 | Mazda RX-7 Cars & Trucks

1 Answer

Where is the interior fuse box in my 1991 mazda rx 7


try downloading the factory shop manual at foxed.ca

Jan 01, 2013 | Mazda RX-7 Cars & Trucks

1 Answer

The mazda rx8 is hard starting and not idling properly. How do u set the timing for the rotas. Do u have a diagram


there are no timing on the rotors for a wankel engine. The timing is controlled by a computer for the RX-8. The sensors & distributors can be adjusted on the RX7's & other Mazdas but I know that there were major engine changes to the RX-8 so I can't tell you for sure. I use to have an RX-7 and worked on it all the time.

Aug 03, 2012 | 2004 Mazda RX-8

1 Answer

I have a 1988 Mazda Rx-7 non-turbo and not all the time but every now and then when i go to start it it cranks but wont start. Is the engine flooding or is it something else?


I always start my '88 RX7 with a 2 start procedure. First start is short about 3 engine revs...second time it always starts.
If I don't do that it cranks & cranks.....try it.

Mar 07, 2011 | 1988 Mazda RX-7

2 Answers

91 mazda rx7 cooling problems


run the car with the rad cap off until the thermostat opens[top rad hose will be warm] then shut off the engine.wait a couple of minutes and recheck the fluid level,this should get rid of the air.if ithis does not fix the problem then the head gasket may need to be replaced.

Sep 24, 2009 | 1988 Mazda RX-7

2 Answers

Where is the starter located in the 1989 mazda rx-7


if you follow the red power lead it should take you to the starter motor

May 26, 2009 | 1989 Mazda RX-7

1 Answer

Problem with the 8 pack seal on a 1991 mazda rx 7.


I think that you might mean your APEX seal and in order to replace that you should probly just get the motor freshened up which isnt rebuilding it so it wont be so expensive.

Mar 15, 2009 | 1991 Mazda RX-7

1 Answer

I have a 1985 mazda rx-7 with carb will start won't turn over


Check the coils by swapping where they are at and see if that changes anything

Feb 14, 2009 | 1985 Mazda RX-7

1 Answer

87 mazda rx 7 n/a cutting out at 4000rpm


Sounds like plugged up pre cats, my NA had the same problem I got a Racing Beat header that eliminated the pre cats and it went away. I've also seen them on eBay for cheaper. Either way you can't lose the stock header is like a cast iron stove attached to the engine it's heavy and massive.

Dec 03, 2008 | 1987 Mazda RX-7

Not finding what you are looking for?
1991 Mazda RX-7 Logo

Related Topics:

295 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...