Reset the Tire Pressure Warning light.

it needs to be reset, here is the procedure>>>http://library.motoralldata.com/techRef/WebHelp/Tire_Pressure_Monitor_Reset_Procedures/Toyota/2005-2006_Solara.htm

This should automatically reset upon proper tire inflation. If you are still getting a low pressure light then the RF chip in the tire is faulty and needs to be replaced. These are rather expensive and can be purchased from dodge.

Tyre pressure warning light.Check pressures,then reset light
Owners manual will show how to

With the factory air pressure monitoring system of the dodge vehicles the light should automatically reset when the tire is reinflated to the proper pressure. If the light remains on after adjusting the air pressure then the problem lies at one of the individual sensors located at the valve stems on the rims

power knob hold it down. now pay me

1. check and make sure that your tires are inflated to the correct pressure

2. turn the ignition switch to the ON position. If the low tire pressure warning light comes on, push and hold the tire pressure warning reset switch (think the switch is in the glovebox, but not sure) until the warning light turns off and then release the switch.

3. now press and hold the tire pressure warning reset switch until the low tire pressure warning light blinks three times.

4. initialization is *not* completed until driving at the vehicle speed of 19 mph or over for more than one hour. the tire pressure monitoring starts when initialization is completed.

If your vehicle has similar controls like my 2006 Sequia. put the ignition in the ON position... then press the Tire Pressure Monitor Reset button (it is located on the dashboard button right beneath the streering wheel column).. press it for 4 to 5 seconds till you see the pressure monitor light come on and then go off. That should reset the system.

this would be a low tire symbol have you tire pressure check it will come on when one off your tires get a little low. the light will reset itself after the proper tire inflation is put in ..thanks for choosing fixya

Hold down the reset for a few seconds until the light goes out. If this does not work, repeat.