Wonder if anyone out there knows which wire is which on the 97 Toyota Tacoma power mirror,trying to build a wire harness for a set of power mirrors. 1.yellow/w blk stripe 2. white/w blk stripe 3. solid gray 4. gray/w grn stripe 5. gray/w red stripe 6. pink/w green stripe 7. pink/ w blk stripe any help would be greatly appreciated. Glen

-It short to ground.


Good luck

Mai

Check for burnt fuse. Check for loose, corroded, burnt or melt connectors at rear of the mirror switch and within the mirror assembly.
Also jiggle the wire harness at different points while keeping the ignition switch at ON position

You must remove the door panel to remove the mirror and disconnect the wiring harness tothe remote mirror.

Remove Old Mirror
1. 1 Open the side door to the Chrysler Town & Country, and find thescrew that holds the side mirror molding in place.
   
2. 
   Take the screw out and remove the molding panel that attached around the outside of the power mirror.
   
3. 
   Remove the bolts connecting the mirror to the door assembly. If equipped, unplug the power side view mirror wiring harness connector.
   
4. 
   Unplug the electric connectors, and pull the mirror out of the molding.
   

Possibly HERE find the diagram.

Pull off the triangle shaped cover on the inside of the door panel over the mirror area by prying it off.
Remove the three 10mm nuts behind the cover, unplug the connector and slide the mirror off the door.

Here is repair information from Mitchells:
1) Disconnect power mirror switch connector. Connect test light between power mirror switch harness connector terminal "A" (orange wire) and ground. If test light illuminates, go to the next step. If test light does not illuminate, repair open in orange wire between power mirror switch and righ rear power distribution center fuse block No. 1 (located under left side of rear seat).
2) Connect test light between power mirror switch harness connector terminals "A" (orange wire) and "J" (Black wire). If test light illuminates, check for poor connections at the power mirror switch. If connections are okay, replace power mirror switch. If test light does not illuminate, repair open in Black wire between power mirror switch and ground.

1. Remove the door inside handle as follows:
   1. Remove the screw and slide the handle forward.
   2. Disconnect the handle from the control link and remove the handle.
2. Remove the door trim as follows:
   1. Remove the 2 caps and 2 screws.
   2. Using a screwdriver, remove the door trim upward then disconnect the connectors.
   3. Using a screwdriver, pry the forward of armrest panel and remove the panel.
   4. Remove the 2 screws and tweeter speaker.
   5. Disconnect the connector, remove the 5 screws and speaker.
   6. Disconnect the wire harness and remove the 2 grommets and service hole cover.
3. Remove the cover and disconnect the power mirror connector.
4. Remove the 3 nuts and outer rear view mirror.

To install:

1. Installation is the reverse of the removal procedure.
2. Tighten the mirror nuts to 8 Nm (71 inch lbs.).

Good luck...

Please use this link:

http://www.autozone.com/addVehicleId,2535402/initialAction,repairGuide/shopping/repairGuide.htm?pageId=0900c152800379b8

Good luck...