At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
not exactly same steps but similar. Most cars I have worked on the screws were along the bottom and on the arm rest. Make sure you remove all screws some may be under a access panel. Use caution when pulling on clips
NEED RADIO HELP! ... Help not start Lancer GT 2012 EngineOverheating STOP SAFELY warning on ... AC ISSUES 2011 Mitsubishi Lancer ES · 2008 Lancer GTS no start please ... 2011 lancer no sound · Driver/Passenger side floor squeaky? ... plastic piece of rear shelf rattles a lot · Very loud noise on Lancer ES 2008 ...
You will first have to access the trunk and then access the tailight assembly - possibly by removing the upholstery of the molding (not too difficult). The bulb housing can be removed by rotating approximately 90-degrees counterclockwise and pulling the assembly. Simply pull the bulb straight out and insert the new bulb. Be sure to test it before reassembling the unit. Finally, reverse the steps.
Most auto parts store have replacements with self adhesive tape on the back. Peal and stick, just remember to clean the surface good. Also, they may need to measure the passenger mirror to give you the correct size.
open the passenger side door there should be a plastic cover usually a flathead screwdriver will remove it once that is removed there should be 3 or 4 bolt to remove and a power cable remove all and replace. good luck
you need to remove the door panel ,to install mirror assy-tere are no special tools(10mm socket,ratchet and #2 phillips screwdriver)3 nuts hold the assy. to the door and the connector is easy to see,there are no special sealers needed(seal is already on mirror assy)good luck!
×