Dash lights, tail lights and brake lights do not work. Could these be related from 1 switch? Fuses are OK

Do your brakes lights work? You replaced the switch was this the light switch that is found on the firewall that is activated when the brakes are applied?
If not, replace that switch. it is found underneath the dash on the driver side.It has a button that is depressed when the brakes are applied.

First check fuse that is for tail lights, Check Owners Manuel under fuses, sometimes fuses control more than one circuit . Is there a dimmer switch for the dash light? Again check owners Manuel. Check the tail light bulbs themselves, make sure there is no corrosion at the bottom of the bulb and contact.

Sounds like you may have a short within the brake light switch itself. I'm not familiar with the vehicle but this electric switch will likely be located under the dash on the brake pedal itself.

check earth wires for light circuits and dash

Most certainly a wiring fault, you need a wiring diagram, these items are related as in all on same circuit. Check rear of fuse box.

does the high mounted brake light work? the brake switch has 2 contacts one for the high mount (LT BLUE/BLACK) and one for the tail brake lights. The tail/brake light wire is LIGHT BLUE. the main connector between the brake light switch and the tail lights is C208 which is located behind the rear seat, left side. So if there is power coming out of the brake switch OK and no power at the tail lights, check that connector. Hope this helps.

Sounds like a blown fuse or a ground wire broke.

under the dash board, up behind the brake pedal mounted on a bracket, is the brake switch, that might be bad.

Check the switch that brightens and dims the dash lights