Question about 2004 Honda Accord
First, take a good look at what you’re doing.
Look on the right side of open glove box and locate a plastic lever. You will see grooves on the end connected to the glove box. The grooved area is the spot to place the thumb in order to press this lever off the glove box when it comes time to do that.
Look up under the glove box. You will see two brass colored screws one on each side of the bottom of the glove box. These screws go up through two square plastic hinges that are attached to the glove box and into the the dash frame.
Okay, with the glove box closed remove the two brass colored screws, and put them aside so you won’t lose them..
Open the glove box and hold the glove box with your left hand and press on the plastic lever (grooved area) located on the right side of the glove box. This lever (the lever already mentioned above) is slotted and will pop off the glove box.
Put the glove box carefully aside.
Look straight in behind the glove box. You will see a rectangular black plastic cover approximately 1.5 inches wide by 8 inches long. On the right and left side are arrows pointing in. Press the arrows and pull out on the cover. This will slide out the tray that holds the filter. Remove old filter and insert the new one, flow arrows pointing down.
Retrieve glove box, hold in place, and attach plastic plastic lever to the right side of the glove box. The reverse of removal.
Next, the two plastic hinges located on the bottom of the glove box fit underneath the dash frame.
While holding the glove box in place (the glove box latch may hold glove box in place while installing screws) re-install the two screws through the plastic hinges into the frame and tighten.
Hope this helps you.
Posted on Oct 30, 2009
Usually, press the side check straps of the glove box inward and pull down. Refit is reversal of removal.
Hope this helps
Posted on Oct 30, 2009
hey jack open the back door and look up top where the hinges are and that should be the one for the back and the front if it is not up under the hood where the wipers are then check up under the dash
Posted on Apr 04, 2009
Remove the three torx screws using a torx-20 screwdriver...pull back the padding in the footwell...there is tab holding the left part of the plastic piece, use a flat-head screwdriver
to pop it out...you may need to disconnect the light connector, and the cigarette lighter connection.. Once the plastic piece is out, you will see a large white box, the filter is
inside this box. There are two yellow clips that need to be slided to the
left/right. The box then pops out from below and the folded-filter will fall
Good luck..i hope this helps..please rate me a fixya.
Posted on Aug 02, 2009
Open the glove box and there are push out tabs on the left and right side pop them out. Now watch it because you are about to dump the contents of your glove box on the floor. let the box hang freely from the lower hinge and look in the back. You will see a white panel that pulls out the panel has a tray attached with the filter element in it remove old element and replace with new 20ish bucks at the parts store lots more at the dealer. re-install filter tray and reverse your removal steps to re-install. Recommended approx 15k or annually
Posted on Nov 04, 2008
Tips for a great answer:
Jan 20, 2016 | Cars & Trucks
May 03, 2011 | Suzuki Grand Vitara Cars & Trucks
Apr 10, 2011 | 2006 Ford F-150
Apr 26, 2010 | 2002 Toyota RAV4
Oct 09, 2009 | 2006 Toyota Corolla
May 05, 2009 | 2004 Toyota Avalon
Mar 15, 2009 | 2005 Kia Amanti
Oct 20, 2008 | 2004 Toyota Avalon
1,492 people viewed this question
Usually answered in minutes!