Where is the rear blower motor resistor on 2001 Dogde Carvan?

First check ballast resistor in the air duct under hood.

Your resistor is burned out that is why you only get high speed. Also the front blower motor is out. But check the wiring going to the resistor and make sure it is not burnt, if it is it also has to be replaced. Just went through the same issues.

please go to this site for more info. http://www.ehow.com/how_7669595_remove-caravan-blower-motor-resistor.html this is for a 1998 dodge caravan. hope this helps ! good-day !

You should be replacing the blower motor with the resistors. If your buying the parts from the dealer an experienced parts person will insist you replace both at the same time. The blower motor is usually what burns out the resistors.

The Blower Motor Resistor is located behind the glove box on the dash. Remove the whole glove box to access. The Resistor is mounted against/sort of into the fire wall.
1. Disconnect the negative side of battery.
2. Disconnected the Electrical Connection to the Resistor.
3. Remove the bolts/screws. I believe they have 8mm heads, there should be 2 of them.
4. Replace with new one/Replug electrical connection.
5. Reconnect the negative side last.
6. Test System before putting the glove box back in!
The Blower Motor is easy (compared to $1000) to remove and replace.

if the resistor from a dealer . if not get 1 from the dealer

It is the blower motor resistor located behind the dash glove box. Take the glove box out to access and change. It is mounted on/into the fire wall.
Very easy to access, remove and install a new resistor.

Do you mean the blower motor resistor? That is usually the problem. It is under the hood, passengers side, above/behind the strut tower.

Sounds like you need to replace the Blower Motor Resistor. It is located on the bottom of the heater box about where the passengers left foot would rest, behind glove box. It has 2 screws holding it on.

If you are looking for the fan blower resistor, it is located behind the glove box. No tools need to get to it and a nut driver to remove the 2 screws to replace it. A 20$ part.