Ignition key must be “off”
• Press and hold the trip odometer reset button in the instrument
cluster (left button), and turn the ignition key to the first position.
• Keep the button pressed for approximately 5 seconds until one of the following words appear in the display: “ OIL SERVICE, or “INSPECTION”, with “RESET”.
The service due is shown with “reset” if the coded minimum consumption
limit has been reached and resetting is possible. If “reset” is not
shown, the minimum limit has not been reached and resetting is not
possible.
• Press and hold the reset button again until the word “RESET” begins to flash.
• While the display is flashing, press the left button briefly to reset
the service interval. After the display has shown the new interval the
following will appear:
This is not correct.
Here is what to do.
turn the car on. Wait about a minute for the computer to get to normal.
press and hold the travel mile reset button. HOld it untill an ! in a triangle appears. then your maintanance info will pop up. select the item to reset. and tap the side button on the wand atached to the stearing wheel. this button is what you use to browse through your computer. press the button once it will say "reset" press and hold it the second time and it will say reset, hold for 5 seconds or so and it will show a check mark next to
"reset" confirming it has reset.
Hope this is helpfull, if you need further help post and i will check back
RJ
i did that and it came up- 19000 miles or 1/2013 can that be right ?
K I'm normally too busy repairing bmw's in my shop to add comments but just had to say ry234 u the man ... ur procedure worked just as u said.
Ron/Auto Europa
THANKS RJ!! Geez, I read 10 or more postings on Bimmerfest about resetting the Oil Change service light and most of the responses started with "Try searching before asking next time, there's a posting every other week about this same question." Then they reiterate the instructions that Parnivaljak0 posted, WHICH DON'T WORK for my 2006 BMW 325i. Your instructions worked perfectly. I'll copy your instructions and post them over on Bimmerfest -- with thanks to you. Thanks again, RJ.
×
SOURCE: how to install hid on a bmw 325xi 2006
Review this tutorial: How to Install HID inside your BMW E36 – DIY
Also, can review this Car Replacement Light Bulb Size Guide – 2005 BMW 325i 325Xi with HID
I hope helped with this. Good luck (remember rated this).
SOURCE: I replace brake lining on bmw 325xi 2006. How do I
Unfortunately, you have to have the service reset tool. Dealers and BMW mechanics have this tool, but i don't know whether they reset for free. i guess it depends on who you take it to.
Regards,
matt
8,555 views
Usually answered in minutes!
×