2000 sl1 air bags have been replaced how do you reset the air bag light

if there was no collision and the air bag light is on there is a code set in the module that needs to be pulled then checked out. with the light on you have no air bag operation. the module can only be reset if the problem is corrected and the use of a scan tool is used to reset module.

YOU NEED AIR BAG CODE SCANNER TO RESET LIGHT/HORN CHECK HORN RELAY /FUSES/WIRING/HORNS CONTACKS IN STEERING WEEL

i understoodd that an air bag error code must be reset by a OBDII reader, not on it's own.

so this may only be a light that is failing when it goes out (i.e. means you may strill not have air-bag operation just because the lights out.
you need to have the codes read to know if there is a general fault with the air bag system or it is a specific bag.

There are no ways to turn off the air bag light except you replace the faulty air bag.

Talking from experience too.

Take care. And rate this please.

think it might be a dealer only job ,most vehicles have a double standard in the software ,so something thats security or safety is encrypted .

sounds like your alternator is not charging.I would have that checked first.Also check battery terminal bolts/ cables

Air Bags For S-Series Should Fit 2000-2002 All. SDM's there are 2 part # 's One for Standard Air Bags & One For Air Bags With Side Curtain Inflators!!

On my 2000 Oldsmobile Silhouette, the air bag light occasionally comes on. What I found is that under the drivers seat, there are some electrical connections. Make sure all of those are tight. Make sure you have nothing under the drivers seat pushing on the cables.

I strongly suspect you have a bad connection or corroded connection at one of your connectors.

Here's the LFC (lamp Fault Codes) for 36:

B1993 36 22 Driver Side Air Bag Circuit Shorted to Ground GO to Pinpoint Test V . B1992 36 24 Driver Side Air Bag Circuit Shorted to Battery or Ignition GO to Pinpoint Test W . B1994 36 26 Driver Side Air Bag Circuit Resistance High GO to Pinpoint Test X . B1995 36 28 Driver Side Air Bag Circuit Resistance Low GO to Pinpoint Test Y .

replace the clock-spring ribbon contact under the steering wheel, that is the problem, u have lost the connection due to a broken ribbon contact.