185 ft.lbs
wrong, Hub to knuckle bolts are torqued to 120 ft. lbs.
Axle shaft nut is torqued to 185 ft. lbs.
×
Rear torque spec for 05 dodge ram 1500
SOURCE: Replaced rear axle pinion bearing and seal, need
There is no torque specs,this nut has to be tightened back like it was ,the best thing to do,was,to late now,is to use a torque wrench to remove the nut,and remember the torque,and when replacing it,torque it back to that spec,the reason being,there is a crush sleeve between the front pion bearing ,and the rear pinion bearing,and it has to be crushed to a certain amount,to aquire deepness into the ring gear,anyway just give it about 25 lbs torque,any more the crush sleeve will crush even more and the deepness of the pinion will be too much.
SOURCE: i need the touque specs
HUB AND BEARING ASSEMBLY NUTS TORQUE TO 125 FT LBS THE HALF SHAFT AXLE TORQUE TO 185 FT LBS.
Tighten the spindle nut to 149 ft-lbs to seat the bearing then
. rotate the axle 5 to 10 times to seat the hub bearing, then
tighten the spindle nut to a final torque of 263 ft-lbs I would just use a good impact gun to get it there.
11,135 views
Usually answered in minutes!
×