Bare with me because I am trying to remember this from memory. If you open your trunk and look on the inside next to the light being replaced, you should see three black protectors which probably appear to hold up the trunk carpeting interior. Remove these protectors and pull back the carpeting (held on by velcro attachments). You should now see three bolts with retaining nuts. Remove the nuts with a deep 10mm socket and pull the light from the body from the outside of the car. After the light is out, you will see three light sockets. The brake light should be the most inner light. Twist the socket towards the left and the light should easily come out. Remove the bulb and replace it with the exact same bulb. The bulb has two filaments, one for the park lights and the other for the brake lights. After you've replaced the bulb, installation is the reverse of removal.
SOURCE: need to know about changing the timing belt on my 2001 mitsubishi
This will take about 3-4 hours. If you look at the drive belts, they will all have to be taken off to get to the timing belt. The engine crankshaft has to be positioned for marks to line-up. The crankshaft will have to be prevented from turning so you can take off its drive pulley. Rotate until the alignment cylinder is near TDC, remove sparkplug, then packing a small rope on top of the piston prevents the engine from turning.. Once you change one timing belt, you will never buy another car with a timing belt again. You can get a manual on eBay.
SOURCE: Need help in locating starter on a 2001 mitsubishi
they at the back of the motor just at the top or could be at bottom at back of gearbox
SOURCE: need radio code for 2001 mitsubishi galant
I read on another site that if you get locked out, your radio will show OFF. All you need to do is keep your radio on for an hour. It will reset itself. Your car doe not need to be on. Not sure if this works, but it is worth a try and may save you $80!!
SOURCE: 2003 MITSUBISHI GALANT HOW TO REPLACE HEADLIGHT BULB
This is correct except your dont need to loosen any screws, at on my 03 galant you dont. The wire clip is a spring clip and just need to be unclipped and it will swing out of the way.
267 views
Usually answered in minutes!
×