I am not familiar with the model but the vehicle handbook usually contains instructions and diagrams on bulb replacement. If stuff has to be removed to change the bulb the book will usually tell you to take the car to your nearest dealer.
Many headlamp bulbs need a strong light, a mirror and a great deal of patience...
SOURCE: location of fuse box/panel for 2004 yukon denali xl
The fuse for the cig lighter is in the fuse panel under the hood on the drivers side. it is marked "cig ltr".
SOURCE: Cabin filter for a GMC Yukon XL 05
They no longer used a cabin filter after about 2003. The cover is there buth it is molded shut with plastic welds.
SOURCE: replace factory radio on 2002 yukon xl
all you gotta do is carfully pry the dash panel off (prying from the far left end is easiest) completely remove panel. then there are 2 clips that hold the factory sterio in place. push on the both clips while pulling the radio out. simply disconnect the wiring harness from the back of the radio. using an adapter avaliable at your local radio shop (scosche p/n gm02, mdarb and gm1483b) wiring harness, dash install kit, and antenna adapter. then simply match the colors on the new radio's harness to the adapter harness, crimping each connection with a "but plug". then simply follow the instructions included with the dash install kit to assemble the kit.connect the antenna adapter to radio, plug in all cables. test to see if everything works properly before the final install. install sterio into dash install kit, re installing kit where origional radio was. then simply put the panel back in its place by firmly pushing on it untill it snaps into place. then enjoy your new radio!
SOURCE: removing the 2nd and 3rd row seats
3rd row, you simply pull the lever which makes the back fold down and then grip the handle located on the bottom and pull toward you slightly hard. They are heavy so it seems like they aren't coming out, just pull hard. second row, you flip all the way up and push with them standing up and they come unhooked. Good Luck! I didn't have any problems, except they are at least 50+lbs!
SOURCE: light replacement
Just reach behind the bumper and grab the light/electrical harness and twist is either way and then it should pull out put in a new 194 bulb and you are set.
1,098 views
Usually answered in minutes!
×