I just got a new starter at the garage and now I see my clock isn't on. Can I fix this or do I call the guys at the garage? I had to reset the radio, so I figure they turned the battery off or something while it was there to get to the starter. I know nothing about wires, so I may not be able to do it myself, and I don't know if it's a big job for the repair guys to go back and fix it either.
SOURCE: Canon Printer Setup & Support Call 1-8O5-225-669O We are 24 Hour Available Call For Help.. Number
I have the same problem here in Canada. I have tried the techniques that come with the book, but to no avail.(factory Homelink, with 3 buttons)
SOURCE: 2000 toyota camry clock don't work ,why?
more trouble than its woth to repair .its digital and you have to remove the too much to do it.buy a cheap watch and stick it on the dash
SOURCE: torque settings for big ends on a 97 toyota camry 220sei
On the V-6 it's 25 Nm (18 ft lbs) on the first pull and then you rotate the next pull 90 degrees using a torque angle wrench.
Checking the specifications for the four cylinder:
25 Nm (18 ft lbs) on first pull and 90 degrees
on the second pull using a torque angle wrench.
SOURCE: clock and ciggert lighter fuse located
U DON'T FIX FUSES U REPLACE THEM, REFER TOT HE OWNERS MANUAL FOR LOCATION OF FUSES.
SOURCE: I have a 1992 V6 toyota camry and I need to
I would suggest getting the manual for your car and reading the steps a few times and then doing a dry run sort of speak cause the manual will have you jumping from chapter to chapter when removing components to access the waterpump.Then make sure you have all the tools,gaskets,o-rings,clamps that you need to start and finish the job.It will make it alot easier and quicker if you have everything you need on hand so you dont have to stop and go back to the parts store.Take your time and make sure you lay everthing out the same way you removed it so you can replace it back the same way.You can do it !
207 views
Usually answered in minutes!
×