07 Camry SE Sun Visor Broken

sun visor pivot point has broken plastic around post to hold visor up . the whole visor will need replaced to correct issue

I forced a small nail between the visor rod and the tube (or whatever) the rod goes into in the visor itself. That created enough tension or drag to hold the visor and keep it from drooping. The visor now works in all three positions.

That can be answered by continentalmotors.com or possibly by hemmingsmotornews.com

My 2007 camry's sun visor (driver side) was broken and it was fixed by toyota dealer saying there is a recall. check with your nearest toyota dealer.

To be honest, Save your 90.00 and pop it in your self. Sun visors are very easy to change and will take you all of 5 minutes. Most visors are held in place by 2-3 little screws that you will see at the base of the visor and looks like they are screwed into your roof. just take the screws out and the visor will pop right out for you. then just do the opposite to install it. It really is that easy.

Good Luck and I hope this helps.

Twitter, SwiftAuto

swiftautorepairs.com

I am on my third driver side visor and second passenger side visor. It seems there is a problem with this part. I am contacting Toyota about this issue.

most likely a defect. call the dealer and see if toyota has issued a recall on the visor and you might have it replaced for free. other than that, there's always the junkyard.

My 2008 Camry driver side sun visor just broke and it will not stay in the up position. is flops down about three inches just enough to bug the **** out of you while driving. another toyota problem that should be recalled since it seams to be common

inside the sun visor there is a spring which is moving to side when you push down the spring pushes side so it will keep down when you want to push to the normal possition spring releces and keep to that possition any way i would like to advice you to replace sun visor.

This works on any visor. Obtain a small clamp as used in wiring harnesses. On the shaft end of the visor, 1/2 inch from the end, install the clamp around the visor and the shaft. Drill a hole through the visor for the clamp screw and tighten as needed. I might be a redneck, but it works!!