The PCV valve is going the way of the carburetor, they are being phased out by "most" companies. If you can't find it, most likley it's not there. Thank you, Dana
PCV is located in right hand valve (passenger side) cover about center of cover .
The PCV Monitor consists of a modified PCV system design. The PCV valve is installed into the rocker cover using a quarter-turn cam-lock design to prevent accidental disconnection. High retention force molded plastic lines are used from the PCV valve to the intake manifold. The diameter of the lines and the intake manifold entry fitting are increased so that inadvertent disconnection of the lines after a vehicle is serviced will cause either an immediate engine stall or will not allow the engine to be restarted. In the event that the vehicle does not stall if the line between the intake manifold and PCV valve is inadvertently disconnected, the vehicle will have a large vacuum leak that will cause the vehicle to run lean at idle. This will illuminate the MIL after two consecutive driving cycles and will store one or more of the following DTCs: Lack of O2 sensor switches, Bank 1 (P1131 or P2195), Lack of O2 sensor switches Bank 2 (P1151 or P2197), Fuel system Lean, Bank 1 (P0171) or Fuel System Lean, Bank 2 (P0174).
I have a 2004 Ford Expedition 5.4 and it has a PCV Valve
It is located on the right hand valve cover about halfway back.
777 views
Usually answered in minutes!
×