How do you know the brake light switch is ok ? Did you check (with a voltmeter) battery voltage at the switch.
Inspection and Verification
Visual Inspection Chart
Mechanical
Electrical
PINPOINT TEST H: THE STOPLAMPS ARE INOPERATIVE
Test Step Result / Action to Take
H1 CHECK CIRCUIT 10 (LG/RD) FOR AN OPEN
Disconnect: BPP Switch C278.
Measure the voltage between BPP switch C278 pin 1, circuit 10 (LG/RD), harness side and ground.
Is the voltage greater than 10 volts?
Yes
GO to H2 .
No
REPAIR the circuit. TEST the system for normal operation.
H2 CHECK THE BPP SWITCH
Connect a fused jumper wire (20A) between BPP C278 pin 1, circuit 10 (LG/RD), harness side and BPP C278 pin 2, circuit 511 (LG), harness side.
Do the stoplamps operate?
Yes
INSTALL a new BPP switch. REFER to Brake Pedal Position (BPP) Switch in this section.
No
REPAIR circuit 511 (LG). TEST the system for normal operation.
×
55 views
Usually answered in minutes!
×