2005 mazda 6, 107 000 miles, when cold in the morning engine starts normally, when you turn it off and starts agailn when hot, too. But after you wait few minutes it will take 5-6 seconds to start, or you have to try twice.
I replaced spark plugs and wires, did not help.
You will get your solution and all info on service info, repair info, parts info, wiring/electrical/fuse diagrams,
error/fault codes, torque specs, PCV,
owner's/service/repair/parts/maintenance manuals etc everything
this website www.reliable-store.com
it's a very good website for vehicle problems even as old as 1991 ford..
SOURCE: 2001 mazda protege will not start
well, with all that you have changed the only two possible things that are left PCM and the ECM....
Do you have an alarm system on this vehicle? If you purchased this car second hand it may have something that is inhibiting the engine from firing. From what you have told us here that would be where I would start looking.
I really hope this is helpfull
SOURCE: #5 cylinder misfire
I have a corolla and had #4 cylinder misfire also diagnosed at autozone. After changing the spark plugs, problem persisted, along with the same error code, so they recommended changing the spark plug wires, and that is what fixed it. I would have changed the rotor cap too, but was low on dough. Glad that was not the problem.
SOURCE: 1998 mazda 626 stalls
I have a 91 mazda 626, runs great cold, but after 5 mins it stalls and won't start. After a few hrs it will start again, and 5 mins later it stalls and won't start.
SOURCE: Looking for the fuel filter in a 2005 mazda 6
It is attached to the fuel pump. Both are located in your fuel tank.
SOURCE: serpentine belt diagram mazda 6 2005
Here are links to the diagram...
If your engine is the 2.3L 4 cyl... http://www.gates.com/common/part_locator/view_diagram.cfm?id=S7042
If your engine is the 3.0L V6... http://www.gates.com/common/part_locator/view_diagram.cfm?id=S6036
1,231 views
Usually answered in minutes!
×