Question about 2002 Ford Thunderbird

1 Answer

I need a steering column motor for my 2002 Ford Thunderbird and can't find one. Is there a place that sells refurbished ones? I'm desperate

Posted by Anonymous on

Ad

1 Answer

Mike Duffy

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 1,084 Answers

Try a local starter/generator repair shop they do many of the small motors on combines and heavy trucks.

Posted on Oct 15, 2021

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How do you replace multifunction switch in a 1997 ford thunderbird?

Hey Dana,

First off be sure to take off the negative battery cable then the positive. Wait a couple of mins. so your airbags don't deploy. Remove the steering column cover and then the two retaining bolts. Pull the switch out, unplug the connector and withdraw the switch assembly from the steering column. With new switch plug in the electrical connector, place the switch in position and install the screws. Tighten the bolts securely and put the steering column cover back on. Put the battery cables back on.
1helpful
1answer

2002 ford explorer won't start after we put in a steering column.

are you using a different ignition switch and key? they have a transponder in the key and it is specific for the vehicle.
1helpful
1answer

How do you remove a 1990 ford thunderbird steering wheel?

There will be screws/bolts around the outside(under some kind of covers), holding the center section on. after you get that off there will be one nut right in the center(remove that and pull the steering wheel(most of the time you need a steering wheel puller)
0helpful
1answer

Where is hazzard flasher at on 91 thunderbird

the hazard switch is on the steering column a little of to the right ( like the 1 O'clock position) the relay for the flashers is under the dash on the drivers side, towards the kick panel.
6helpful
2answers

Can you replace the lights behind the instrument panel? the entire right side of my dash is no longer lit up

Sure Can

Buy bulb number 161

Instrument Cluster Finish Panel

Removal and Installation

1. Remove three screws along the bottom of instrument panel steering column cover (04459). Pull on instrument panel steering column cover to unsnap the three clips across the top of the instrument panel steering column cover. Remove the lower instrument panel steering column cover.

1996fp.gif

2. Remove four screws retaining the steering column shrouds (3530) together and remove the steering column shrouds.

3. Remove the three screws retaining the bottom of the cluster instrument panel finish panel (044D70).

4. Remove two screws retaining the cluster instrument panel finish panel above the instrument cluster face.

5. Pull cluster instrument panel finish panel to unsnap one retaining clip above the LH A/C register (19893).

6. Pull cluster instrument panel finish panel to unsnap three retaining clips on the RH side vertical edge.

7. Pull cluster instrument panel finish panel away from instrument panel (04320) far enough to disconnect the wiring connector(s).

8. To install, reverse Removal procedure.

I've never done #2, and #1 refers to the panel below the steering column. To remove it completely, pull it towards the driver's seat. There may be retaining clasps on it also.
0helpful
1answer

My blinkers dont work on my 1989 Ford thunderbird I have changed the flasher and the turn single switch what else is there to do

is the lever that reaches into the steering column loose or "floppy" feeling? if so it could be a broken turn signal cam. a circular device inside the column beneath the steering wheel
2helpful
1answer

Do i need to pull the steering wheel off with a puller to replace the ignition actuator that runs along the gears from key and cylinder? steering column is out and apart, actuator that hooks into ignition...

yes the steering wheel must be pulled, this is a real complicated jub. I have done 100's and still hate it everytime i get one at the shop of the Ford dealer i work at. Make darn sure u disarm the airbag properly!
0helpful
1answer

I can not find the fuse box on the 1990 thunderbird LX


Left of the steering column underneath dashboard or on the side kick panel. Also on the firewall to the left of the
steering column.

Sheilah
0helpful
1answer

The blinkers on are ford don't work we tried to but in fuses but all the fuses work

If the lights come on but just do not flash, replace the flasher relay. Your Thunderbird has 2 flasher relays. One for the Turn signals and one for the Hazard lights. The turn signal relay is located Front seating area, driver side, under dash, driver side of steering column, mounted in lower corner of fuse block . The hazard relay is located Front seating area, driver side, under dash, driver side of steering column, mounted in rear of fuse block. Replace the one for the Turn Signals. Information Curtorsey Auto Zone.
6helpful
2answers

Turns signals do not work on 1992 Ford Thunderbird

I Have A 92 Thunderbird To And Its Located Above The Fuse Panel You Will Probally Need To Remove The Panel Under The Steering Column To Get To It Its Located To The Right of The Steering Column It looks Like A Relay Not The Normal Looking Round Style Flasher
Not finding what you are looking for?
2002 Ford Thunderbird Logo

Related Topics:

22 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

gerry bissi

Level 3 Expert

4390 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6929 Answers

Greg Bernett
Greg Bernett

Level 3 Expert

2993 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...