SOURCE: WHERE IS THIS PORT LOCATED?
Yes, on my 2002 xl-7 the low side port is behind the grill as ibass215 says. The cap is light green and marked with an "L". Thanks Susuki, couln't you find a more hidden place?
SOURCE: how do i adjust my
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
support.
You will have vertical adjustment screws for each independent beam
(separate highs and separate lows, but will be same screw if highs and
lows are the same bulb). You may also have additional horizontal
adjustment screws as well
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
Testimonial: "thanks"
SOURCE: trying to replace alternator on SUZUKI XL7
yes use a small socket wrench as in a 1/4 in drive i had the same problem with my echoe not a lot of room to undo bolt with a bigger ratchet...As for the belt if serpitine you need to remember how to put the belt back in there should be a tensioner pulley that you need to move to remove and replace belts however swinging alternator out of way or removing same will allow some belts to be removed if only 1
SOURCE: suzuki xl7 which side is bank 2 sensor 2
I assume then that this is a v6. Bank one should be the drivers side (I think) . Sensor 1 would be the one before the catalytc convertor and sensor 2 would be the one after it.
389 views
Usually answered in minutes!
×