Well if you do not have a hoist then up need ramps or a really good floor jack and jack stands so you can get under it to where the starter is located .remove battery cable first then under the truck remove the nuts holding the wires to it then the bolts that hold starter motor to the vehicle doing it in reverse when reinstalling .GOOD LUCK
SOURCE: How do I replace a drivers side mirror on an Isuzu
hi, you see the plastic triangle piece on the inside of the car on the back of the mirror well this just pulls off then under this you will see the bolts that hold the mirror to the door you may need a screwdriver to pry the cover off but it may be tight but it will come off.
Once you have this off and start undoing the bolts make sure someone is holding the mirror on the outside cuz if it falls it can damage the wires that adjust the mirror so take your time and you should be ok.
Now the only slight problem you might have is that sometimes the plastic bungs break on this case this happens rarely but can happen, the plastic bit your pulling off is held in by plastic pins sticking into rubber bungs so try to get it off in one go as twisting it can cause these plastic pins can break.
Let me know how you get on or if you need further assistance ok
SOURCE: i need to know how
go to your local parts store,. they will have an OB-II reader where you could reset the computer.
Ck
SOURCE: where is the camshaft position sensor on a 2006
part number and its on the passenger side of cylinder head at the front of engine. They gave trouble when they first came out with this engine on this gm built truck!kroger feedback survey
101 views
Usually answered in minutes!
×