Question about 2004 Nissan Quest

Open Question

Ignition and I/P work. Why doesn't fan and all lights?

Replaced timing chain

Posted by carlos gandarillas on

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1993 chevy c1500 p/u v6, 4.3 liter, 5 speed manual trans wont start


check the valve timing after replacing the chain. check that you connected the ignition module to the coil. Check ignition timing as you may be out 180 degrees on the timing.

Apr 21, 2014 | 1993 Chevrolet C1500

1 Answer

Replaced timming chain now does want to run correctly bad fumes


It sounds like the timing chain was replaced one tooth off. The only other option if the timing chain is correct would be to adjust the ignition timing. Since the timing chain was replaced I would think it to be the first problem.

Dec 17, 2013 | Cars & Trucks

1 Answer

Harbor breeze fan lamp..ligths stopped working


The light pull chain switch should be replaceable and available at Lowes or Home Depot .

Dec 25, 2017 | Cars & Trucks

1 Answer

The fan doesn't work on my '89 cavalier 2.8. I replaced the temp sensor and the fan heat switch just above it, still no good. I bypased the switch and wired the fan direct to ignition side of fuse...


Can't remember where they are exactly on yours but there are a group of three or four relays either back on one of the fenders or on the firewall. One of those is for the fan.

May 15, 2011 | Chevrolet Cavalier Cars & Trucks

1 Answer

1995 chevy lumina sensor went out and fan wont turn


How did you determine that the sensor failed. Did the check engine light come on? When you say that the fan won't turn, do you mean that it won't turn on and run or that you can't physically turn it by hand. To determine this, disconnect the electrical connector to the fan and try to turn it by hand. It should turn easily. If it doesn't then it must be replaced. If it does then reconnect the electrical connector to the fan and try to operate it by disconnecting the temperature sensor lead and placing a jumper wire between the terminals of the harness. turn the AC control to AC/MAX and turn the ignition key to on. If the fan runs then the problem is the sensor. If it doesn't then check the fan control relay and any related fuses. WARNING : Use extreme caution when testing the fan circuit. Never attempt to turn the fan with the electrical connector in place. The fan can operate at any time even if the engine is off.

May 14, 2011 | 1995 Chevrolet Lumina

Not finding what you are looking for?
2004 Nissan Quest Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14866 Answers

Vincent G
Vincent G

Level 3 Expert

2363 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...