Question about Cars & Trucks

1 Answer

On a 2004 grand prix gt There are the 2 positve lines coming of alt one to + side of battery other joins wrapped into harness where does that positive go

Posted by Jessica Beirl on

Ad

1 Answer

Mikey

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 6,663 Answers

Three-wire alternator include the battery positive wire, the voltage sensing wire, and the ignition input wire. The battery positive wire connects to the starter. The voltage sensing wire connects to the battery, and the ignition wire connects from the alternator to the key switch.

Posted on Dec 02, 2020

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replaced clutch in 2006 kia spectra


if you connect a positive wire to ground , rest assured that you will be looking at a new harness
get a schematic diagram from a workshop manual and do the job properly

Aug 17, 2017 | 2006 Kia Spectra

1 Answer

Kia spectra 2006


positive side connects to the alternator and negative connects to the floor of the car, holds the voltage of the case at ground potential to protect against electric shock.

May 02, 2014 | 2006 Kia Spectra

1 Answer

I have a 1985 Corvette. The battery was dead and I had the charger on it. I went to start the car with the charger on it. There is a wire that runs off the positive side of the battery and into the harness...


The fuseable link that is on it should protect the vehicles electrical at three places one for ignition switch a second for starter control and third for charging control ,The one on the positve is for the charging system

May 08, 2011 | 1985 Chevrolet Corvette

1 Answer

Trying to take negative clamp off battery, pos came off easy. seems to turn after i took the bolt off but just will not open enough to release off the battery. any ideas?


using a screw driver or chisel, find the small line where the battery clamp is joined in half. Put the screw driver or chisel on this line and strike with a hammer firmly. This will spread the clamp out. Also soak it in CRC or similar. You can also use the screw driver as a lever underneath the clamp. Ensure the positive lead is well away from where you are working. It is a good idea to wrap both the positive lead and positive terminal in masking tape to prevent any arcing out.

Jan 23, 2011 | 2003 Land Rover Freelander

1 Answer

99 chev malibu,cooling fans dont come on


make sure it is full of coolant, next check for a bad fan relay, to see if fans are ok! run a wire from positve post on battery to positive on fan motor, ground other side if need be. if fans do not work they are bad, if they do work, check relay to fan and coolant tempurature sensor if needed.

Mar 19, 2010 | 1999 Chevrolet Malibu

1 Answer

Voltage Problem


hello
this style of alt has an internal regulator and these alt. have had a long history of the wiring plug burning up. the one that plugs into the alt. and have started some fires so be careful.
this alt is called a 2G
most auto part houses will have replacement harnesses

Oct 26, 2008 | 1987 Ford F 250

3 Answers

I need to know what colors mean what, so i can hook my cd player up


Red - Power
Yellow - primary power must be joined to the red
blue - Remote
Black - ground or negative
To find your speaker wires check the color of the cord behind each speaker than match it with the same color in the dash.
or the easy way is to use a normal 1.5v penlight battery and try each speaker cord behind the dash and listen to which speaker give off a crackling noise so you can get the balance on the cd player right.
If u trying to find power in the car and don't have a tester than get a 12v light or bulb join the negative to the body and push the positive wire into each one of the holes in the factory plug in the dash one at a time until the light comes on. That is your positive the rest is easy. (DIY guru)

Oct 09, 2008 | 1991 Honda Accord

1 Answer

I have a 1959-1962 Honda C102 Super Cub 50cc Scooter, with electric start, that has a 6 volt system, that I am trying to get running. I have a new 6 volt battery, fixed a lot of wiring problems, and was...


large wire off starter will go to positve battery, the small yellow/red wire should go to the starter solenoid, and the battery should be hooked up like a nornal setup please rate -jeff

Sep 01, 2008 | 1995 Honda Civic

1 Answer

Need cig.litter to work for music connection


voltage is the power supply. you always run atleast a 10/12 ga wire to positive side of battery. also remember that will also need a ground. keep the color code for positve voltage to either red or yellow for positive and black or white for ground.

Aug 13, 2008 | 1999 Pontiac Sunfire

1 Answer

Wire attached to the Positive Battery Cable


disconnect power, with dvom ( volt meter) check for continuity in wire that was spliced. possible bad connection.

Jul 05, 2008 | 1999 Dodge Intrepid

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

john h

Level 3 Expert

23515 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6517 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...