Why wont my van move fires up but doesnt move help

Who are they? a garage? Did you drive it in with a bad motor( or it was moving)? There are plugs that can be crossed on the transmission, but you have to really try to get them to reach. Have codes read, if you can.

Craig, Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."


1987 ford 250 economize van 5 8 liter4v engine firing order diagram Google...
Wants to start but wont Ford Truck Enthusiasts Forums

1987 ford 5 8 liter 4v engine firing order diagram Google Search

i think,it having compressor /otherwise it having some technical problem.

try the ignition coil connector and the ground on the coil which is through the screws holding the coil on, i removed and reinstalled the screws with lock washers to help the ground issue

OK so the engines fires up? This means that the transmission is neutral or park. Try starting the car with the shift in gear. If the car starts but does not move this tells you that the selector switch on the side of the transmission casing is not being moved out of 'park' and therefore the links need to be checked for continuity. If the engine fails to start then the selector has been moved out of 'park' and that although the links from the gear selector in the car to the are OK there is something wrong with the transmission.

first is first check battery and alternator

if the immo light doesnt come on it means the ecu has left the immobilizer on. it is a commen fault on kia. if you lock and unlock the car or sometimes just take the key out the ignition then put it back in it sorts the problem. if you dont see the IMMO light dont attempt to start it because it wont fire

I would pull the plugs and let the gas into the cylinders to dry out , you may have a hydrolock engine after putting so much gas into it , recheck the firing order to be sure is OK ususlly when you see a carb backfiring and smoking the firing order is not right

try replacing the starter solenoid. it's an easy fix.
I had the same problem and could get it to run after tapping (kinda hard) on the solenoid case with a long pry bar, and since I replaced it it hasn't done that no start thing at all. make sure to disconnect your positive terminal of the battery before touching the starter solenoid wiring, or something spectacularly bad WILL result!

is it parked in a steep hill, if so,try to releave some pressure off it,and try to shift it,if not,block wheels so van wont move,inspect shift linkage,if ok,undo linkage from tranny,try shifter invan if it moves ok,if not,inspectshifter and linkange,if its ok,try moving shifter arm at tranny,be careful!if it doesnt move, youll have to take oil pan off tranny and inspect park gear lock.