I wouldn't want to trouble anyone but I've looked online and am unable to find any info on it. I found lots of water pump into though.
SOURCE: water pump trouble on 91 buick park ave
You have to remove the engine mount next to it, then remove the 4 bolts in the pulley Make sure you support the engine with a floor jack, use the jack to raise the engine a few inches on the that end helps getting the pulley bolts out.
SOURCE: Where is the power steering refill cap on a 2005
if its a 3.8, it is at the back of the motor on the passenger side, right up against the firewall about halfway down.
SOURCE: replacing power steering pump in a 95 buick regal
i think you need to remove pully first it is a special puller gm has
SOURCE: Water pump removal on a 1996 Buick Riviera (supercharged)
there are two bolts that hold the power steering pump in place that are accesable through the holes in the pulley. If you use a 6" extension and a 1/2" socket you can reach them. this will allow the pump to be removed and hang by the hoses and be out of the way. I was told also to inspect the cam sensor while it is apart because you have to remove the water pump in order to get to it.
SOURCE: Trying to change a thermostat
If you are referring to the thermostat for the radiator fan. You would need the correct socket wrench size or just the correct wrench size to get it out. You will know it is bad when the fan turns on immediately after cold start or even if it the temp gauge is at its lowest when the engine has been switched on. Otherwise it could be a bad fuse or relay for the fan if it does not turn on at any condition.
For AC thermostat. It is a lot more work as you will removed dashboard components and return things. First things out last ones in.
1,138 views
Usually answered in minutes!
×