At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
remove the inner door panel then disconnect the arms that run from the outside door handle, the inner door handle, the door lock mechanism, from each unit. then undo the 3 bolts/screws on the end of the door to remove the door latch assembly.
There are two screws holding the plastic trim panel. Take off the panel and you will see where the handle is attached to a linkage. Remove the retaining clip and replace the handle.
remove the few screws around the pull handle and or door latch handle. Then pry off the panel. This will damage the plastic snap-in holders. They will have to be replaced. they are very cheap at the dealership or probably even any auto parts store...
The blower motor is on the passengers side under the dash.You might have to remove the a lower panel.This is the insulator panel.If the blower works at all just turn it on and follow the noise.Hope this helps.Good luck.
On the inside trim, you can remove screws that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them. You'll need to lift the door panel upwards in order to
get it off the window ledge. Remove the clips and screws securing the old window to the arm and slide it out through the top of the door (may need to be maneuvered out)
Your going to have to remove the inside door panel to get to the two screws that hold the door handle in place. Just make sure your windows are up so the window is not in the way to get to the two screws to un bolt the out side door handle. You can buy the replacement door handle from Auto Zone and buy extra door clips, since they always break. Auto Zone will have the step by step instructions to get the job done and it should take just under an hour, some band aids will be handy too. Good luck and hope this helps, keep me posted, be glad to help.
×