Question about Cars & Trucks

1 Answer

I have no oil pressure after I changed my timing cover on my 07 3800 Series 2 Grand Prix

Posted by Elizabeth A Coffman on

Ad

1 Answer

JonSnell Electronic

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 31,825 Answers

In your situation I would get a qualified mechanic to check your work.

Posted on Jul 14, 2020

Ad

5 Related Answers

Anonymous

  • 50 Answers

SOURCE: 1993 Jeep Grand Cherokee, V6. Oil Pressure Gauge Read High.

it could be the sensor you should look at the oil pressure relief valve

Posted on Jun 10, 2009

Ad
KCGTODAD

Shannon Washam

  • 169 Answers

SOURCE: 1997 grand prix gtp. Tire pressure/abs light

Hello! This indicates a fault with the wheel speed sensor/ABS sensor. Any major auto parts retailer can pull the details of this code (which sensor) for free, which will help you identify if the wiring is loose or damaged or if the sensor will need to be replaced. If you need to replace the sensor - you will need to replace the entire wheel bearing assembly, as the sensor is internal.


Thanks for using FixYa!

Posted on Nov 02, 2009

Anonymous

  • 1985 Answers

SOURCE: HOW DO I RESET CHANGE OIL SOON LIGHT ON A 1998

turn your key to the on position ,push gas pedal completely to the floor three times in 5 seconds
leave the pedal up and wait 10 seconds the light will blink you done!

Posted on Nov 24, 2009

Anonymous

  • 179 Answers

SOURCE: what kind of oil for a 2004 grand prix

no regular oil will not hurt this car. I highlt recommend using a castrol 5-W30 it is tar based oil rather than wax based and will not clog your engine. You can use synthetic oil which costs much more but it is not necessary.

Posted on Dec 30, 2009

Bill Eager

  • 459 Answers

SOURCE: I need to buy oil for my 2005 Pontiac Grand Prix GTP

Check you owners manual.
But should be a 5-30 weight.

Posted on Jan 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 grand Prix oil pressure light an dinging comes on


1. Check your oil level. If oil level is not ok, correct oil level and find out why oil level was low and correct the problem. (Leaks, bad PCV, Burning oil due to severe engine wear, nobody has bothered to check it for the last 3000 miles, WAY overdue for an oil change, etc.) If oil level is ok, proceed to next step.

2. Remove the oil pressure sensor and install a manual oil pressure gauge. Run engine to verify low oil pressure. If gauge shows that the oil pressure is low, overhaul or replace engine. If oil pressure is ok, replace oil pressure sending unit and retest.

Mar 06, 2012 | 2005 Pontiac Grand Prix

2 Answers

What drives the oil pump on a '97 Pontiac Grand Prix 3.1L V6?


I don't think you can damage the oil pump gear when torquing the harmonic balancer. Oil Pump Removal & Installation 3.1L & 3.4L Engine To Remove:
  1. Remove the oil pan.
  2. Remove the oil pump.
  3. Remove the drive shaft extension.
Oil Pump and drive gmpc_v6_18.gif

To Install:
  1. Install the oil pump.
  2. Install the drive shaft extension.
  3. Engage the drive shaft extension into the drive gear.
  4. Install the pump to the rear bearing cap. Tighten the bolt to 30 ft. lbs. (41 Nm).
  5. Install the oil pan.
3.8L Engine NOTE: The oil pump on the 3.8L engine is serviced as part of the engine front cover.
  1. Remove the following:
    • Engine front cover.
    • Oil pump cover screws.
    • Oil pump cover.
    • Oil pump gear set.
Oil Pump in front cover gmpc_v6_19.gif

To Install:
  1. Lubricate the oil pump gear set with petroleum jelly.
  2. Install the oil pump gear set.
  3. Pack the oil pump gears with petroleum jelly.
  4. Install the oil pump cover.
  5. Install the oil pump cover screws. Tighten the screws to 98 in lbs (11 Nm)
  6. Install the engine front cover. NOTE: Do not run the engine until the oil pressure is tested. Running the engine without measurable oil pressure will cause extensive damage.
  7. Inspect the oil pressure.
  8. Inspect for leaks.
prev.gif next.gif

Jul 21, 2010 | 1997 Pontiac Grand Prix

1 Answer

Oil capacity of 2002 grand prix


Right around 4 3/4 quarts. Use an AC Delco filter. There is a difference and this will prevent low oil pressure.

May 22, 2010 | 2002 Pontiac Grand Prix

1 Answer

2002 Grand Prix: I just had my oil changed in my Pontiac 2008 Grand...


To reset "CHANGE OIL" light, turn the ignition switch to the run position without starting the engine. Fully depress and release the accelerator pedal 3 times within 5 seconds. and wait for the light to flash. Check your manual it maybe slightly different. Real easy fix.

May 16, 2010 | 2002 Pontiac Grand Prix

1 Answer

Changed intake gasket and now it won't start. It just spins like it is out of time. I replaced the timing set and it still acts the same. It is a 98 Grand Prix with a 3800 series 2 vin K


So did you replace the timing set first, or after ,it would not start after the intake was replaced. Replacing just the intake would not alter the timing components. The intake is a pretty straight forward job. Does the engine have spark? fuel pressure? The injectors should have power on one side with the key on,check one do they? All wires connected to ign coils? ground wires hooked up? Does the CK. ENG light come on with key on? have ALL fuses been checked?

Nov 15, 2009 | 1998 Pontiac Grand Prix

1 Answer

No oil pressure and i just changed the oil pressure switch in a 90 grand prix


You need to put a mechanical gauge on there and check actual oil pressure...problem may not be the switch but in fact there may be no pressure. Does the engine make noise when running? Do you have the correct switch? What was the problem that caused you to replace the switch?

Aug 10, 2009 | 1990 Pontiac Grand Prix

1 Answer

What are oil pressure specs for a 2006 Grand Prix GT w/3800



Lubrication System

^ Oil Pressure - @ 1850 RPM 414 kPa (60 psi)

With this Piticular Engine The oil Pump Is the ONLY Problem I"ve found that They Are even Slightly Bad At and Not A HUGE Problem at all,Oil sending Unit May very well be the Culpret. Hope this Helps you Diagnose it Correctly.

Jun 15, 2009 | 2005 Pontiac Grand Prix

1 Answer

1995 grand prix 3.1L engine


if it is oil pressure switch it is located in the front of the engine below valve cover and mounted in engine block.

Dec 11, 2008 | 1995 Pontiac Grand Prix

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

23424 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...