Question about Oldsmobile Cars & Trucks
the light bulbs are not replacable unless you can solder, you have to replace the complete instrument cluster, get one from a junk yard 100 bucks.
Posted on Sep 25, 2008
Check all battery connections make sure they are tightly secured. Check for broken battery cables, if all are intact. Check battery/Main Fuse. contact if you need more help. Good Luck
Posted on Dec 27, 2008
The first thing i would check is all 4 abs sensors at the wheels.You can do this with a volt meter set on ac voltage and spin the wheel if it generates voltage at all on the meter its good.
Posted on Mar 06, 2009
This is basicly a very time consuming job rather than a physically hard one to complete. In order to replace the gasket you must remove the intake plenum,throttle body, and misc. vacuum hoses. The wiring harness connections must also be disconnected. Finally the intake manifold is exposed. The bolts holding the manifold to the block are removed exposing the leaking gasket. After removing the push rods and placing them in the correct order to be replaced the gasket and sealants can be removed. Finally replace everything in reverse order. Be sure to consult a GM manual for correct bolt torch specs. The correct specs for the manifold bolts usually come with the gasket. Make sure to change your oil a few times after this job in case any coolant entered the block. Also,change the thermostat and the oil seal on the distributor half shaft cap while you have everything off. Good Luck
Posted on May 12, 2009
Tips for a great answer:
Nov 30, 2016 | 2004 Oldsmobile Silhouette
Oct 02, 2016 | 2004 Oldsmobile Silhouette
Oct 06, 2015 | 1999 Oldsmobile Silhouette
Sep 20, 2015 | 2004 Oldsmobile Silhouette
Sep 02, 2012 | 1998 Oldsmobile Silhouette
Jul 22, 2010 | 2002 Oldsmobile Silhouette
Jun 27, 2009 | 2003 Oldsmobile Silhouette
Jun 17, 2009 | 2004 Oldsmobile Silhouette
36 people viewed this question
Usually answered in minutes!