SOURCE: 1992 Isuzu Rodeo Distributor wires
Hi,
On the 3.2L distriburorless ignition, the firing order is a straight 1-2-3-4-5-6.
Cylinder numbering .
-
Hope this works for you
SOURCE: 1992 Isuzu Rodeo Distributor wires 3.1L engine
Hi,
Isuzu seem to have complicated things by changing engines, firing orders and even direction of rotation! As you can see, they've numbered the cylinders the other way than the 3.2L.
The Firing sequence for the 3.1 (traditional distributor) 6 cylinder is as follows -
If you take the distributor cap off, there should be a "No.1" formed on the inside. Stick a lead on this before you put the cap back on and go from there.
As leads are different lengths, you may have to swap a few to find the best fit.
I think 2 of them will look out of place - but that's the way it's designed. Just make use of clips for holding them neatly.
Thanks for using Fixya.
SOURCE: 2001 hyundai santa fe 6
HI......
OK. just follow the number on the ignition coils.
And the number on the cylinders are.
The FIREWALL side are 1,3,5, Starting from the belts location.
The RADIATOR side are 2,4,6, Starting from the belts location.
The coil with number 1 go to cylinder 1. as the same way the rest of the coils and cylinders.
OK... I hope this solve your question .
THank you for use fixya.
SOURCE: cant find the spark plug location on 2002 4cyl tacoma
Locate the spark plug cover on the engine.On some Toyota Tacoma engines, the cover is across the top of the engine. On others, it is along the side 4 cyl. Remove the cover to reveal the ignition coils and spark plugs wires. The spark plug wires are plugged directly into the engine and the ignition coils are in the tip of the spark plug wire.
Remove the coil and wire from the spark plug. Twist and pull the plug out of the engine. Remove the spark plug from the cylinder well with a socket extender and socket wrench. Turn the wrench to the left to unscrew the spark plug from the engine.
Discard the old spark plug and apply a coat of anti-seize compound to the threads of the new spark plug.
Insert the new spark plug into the socket. Use the socket and extension to screw the spark plug into place.
Return the ignition coils and spark plug wires to the engine and turn it to lock the plug in place. Repeat the entire the process with the remaining spark plugs.
Replace the spark plug cover when all of the spark plugs are replaced.
Good luck and hope this helps and The spark plug tension may range between 11 and 15 foot pounds, depending on the size of the spark plug. The correct tension is indicated on the spark plug's packaging.
SOURCE: Locating and changing spark plugs on 2007 Hyundai Sonata 4 cylinder
They are directly below the coil packs (10mm bolts).
114 views
Usually answered in minutes!
×