Cars & Trucks Logo

Related Topics:

Anonymous Posted on Apr 03, 2020

94 RANGER: check engine light wont light up. When turn ignition key ON.

1 Answer

Dariusz Zalewski

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Cars & Trucks Master 1,095 Answers
  • Posted on Apr 03, 2020
Dariusz Zalewski
Cars & Trucks Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Mar 11, 2016
Answers
1095
Questions
0
Helped
297540
Points
3055

Possibly light bulb is blown

5 Related Answers

Anonymous

  • 5 Answers
  • Posted on Dec 14, 2008

SOURCE: Key wont turn to Ignition point

you need to buy a new ignition tumbler

Ad

Anonymous

  • 1 Answer
  • Posted on Jan 23, 2009

SOURCE: 2002 mazda mpv ignition switch off/engine keeps running/help

change the part

Ronnie Wilson

  • 1596 Answers
  • Posted on Feb 08, 2009

SOURCE: Ignition turns and key warning light comes on. Its a 98 Ford Expl

Sounds Like the Starter RELAY is Bad After Exhausting All other Test, Go For The RELAY
A SURE-SHOT way Is to Jumper Wire From Battery to (STARTER SIDE) of Relay if starter Works then Its the Starter Relay if NOT>>Then Its the STARTER<) Relay Instruction Below. STARTER Instructions Very Bottom
REMOVAL
WARNING: WHEN PERFORMING MAINTENANCE ON THE STARTING SYSTEM BE AWARE THAT HEAVY GAUGE LEADS ARE CONNECTED DIRECTLY TO THE BATTERY. MAKE SURE PROTECTIVE CAPS ARE IN PLACE.

  1. Disconnect the battery ground cable.
    1. Disconnect the starter motor solenoid relay switch wiring.
    1. Remove the protective cover.
    2. Disconnect the push-on electrical connector.
    3. Remove the nuts.
    4. Remove the cable.
      1. Remove the starter motor solenoid relay switch.
      1. Remove the engine sensor/generator wires.
      2. Remove the bolts and ground wire.
      3. Remove the starter motor solenoid relay switch.
      INSTALLATION
    5. Follow the removal procedure in reverse order NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.
REMOVAL

WARNING: WHEN PERFORMING MAINTENANCE ON THE STARTING SYSTEM BE AWARE THAT HEAVY GAUGE LEADS ARE CONNECTED DIRECTLY TO THE BATTERY. MAKE SURE PROTECTIVE CAPS ARE IN PLACE WHEN MAINTENANCE IS COMPLETED.

  1. Disconnect the battery ground cable.
  2. Raise and support the vehicle.
  3. Remove the starter motor solenoid terminal cover.
    1. Disconnect the starter wires.
    1. Remove the nuts.
    2. Disconnect the wires.Remove the nut and the starter ground cable
    3. Remove the bolt and the starter motor.
      1. Follow the removal procedure in reverse order. NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.

Anonymous

  • 1 Answer
  • Posted on Nov 26, 2009

SOURCE: Nissan serena, engine wont turn, inspite of ignition light etc

plizz fix the key system...

Greg Stefan

  • 462 Answers
  • Posted on Jul 15, 2010

SOURCE: I have a 94 Toyota Corolla 1.8. Engine wont start.

Check HALL sensor , it's probably inside the distributor , another name for it is a camshaft position sensor.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

94 ranger 4.0 go to do check engine light test it wont blink just stays illuminated!

Go to Autozone,they will check for free and only takes a few minutes.
0helpful
1answer

Buick lesabre 94,crank but wont start,got spark but not open fuel injectors

Check your fuses. Check at an injector plug for power with the key on. One wire would be power with the key on. The other wire would be a ground pulse when the engine is turning (running or starting). Both wires may show hot but it could just be power feeding back. If you have a test light capable of testing for ground, check for ground as well while the engine is cranking (a noid light is ideal).
If no ground or you cannot test for it, take the ignition module to an autozone so they can test it for free.
0helpful
1answer

94 wrangler 4.0 fuel pump wont turn on

If your check engine light does not illuminate when you turn the ignition on then your jeep ecu is in need of repair. The check engine light has to be on for the fuel pump to get power. Try leaving the ignition key in the on position for a few minutes to see if the check engine light does eventually come on and if the fuel pump starts to work then.
0helpful
2answers

94 honda accord wont start and d4 light is flashing constant. It's cranking but it wont turn over.

my 94 honda the check engine light comes on then the d4 light flashes i can turn off the key and it stops for a minute
0helpful
1answer

Key does not start Truck

do you have a good battery conection? check if horn lights workould ect! could be anti theft issue!?
0helpful
1answer

Key want work 2001 ford ranger, it will turn ignition but want crank truck.

CHECK VOLTAGE AT STARTER BIG WIRE COMES FROM BATTERY, SMALL WIRE FROM IGNITION SWITCH , WITH TEST LIGHT CHECK VOLTAGE AT SMALL WIRE WHILE SOME ONE TURNS KEY TO START POS. IF THERE IS VOLTAGE STARTER NO GOOD. IF NO VOLTAGE CHECK IGNITION SWITCH AND SAFETY NEUTRAL SWITCH.
0helpful
2answers

The ignition bell wont stop ringing

You need to unplug the door harness one at a time to locate which door is causing the problem. Once the door is located, you can replace the switch which is located on the lock mechanism.
0helpful
1answer

Ignition switch 1994 ranger

If it were me, I'd take the Vin # down to the Dealer and get a key made(and take back the ignition you bought). As far as I know without the original key to allow the release pin to depress, the only possible chance might be to try another Ford key and it may release the ignition basket. Or call a locksmith and he can make a key for probably $50. **Or (ha ha) I could make a copy of my '94 Ranger key and send you a copy ! :>)
0helpful
2answers

Clio wont start

In my experience with a 94 ford f150, it was the cylinoid!! If you had your vehicle checked at a professional auto shop, go get your money back. It is the rules and regulations in most shops that they not only check the battery and starter, but to also check the distributer and the cylinoid as well. I have had my truck for 8-9yrs now and I have always had it annually checked thoroughly...it has kept me from walking home when I needed a rig to drive.
Not finding what you are looking for?

76 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...