I need to see exactly where a tremasat is on my Dodge avenger 2008 2.7 6 L

SOURCE: dodge avenger 2008

It depends on who you go to and if you want it done right. I went to the Dealership and had them put front brakes on my 2008 Dodge Avenger and it has been in the shop every 2-4 months since then for front brakes. They replaced the entire front brake system and my 08 Avenger is still eating brakes. I finally took it to a friend who owns a auto repair shop he replace the rotors which are total about 115.00 for each from AutoZone and replaced the brake pads for 50.00 so it cost me just parts 155.00 and my Avenger is running smoothly since haven't had problems with the brakes since. Go to Midas and let them change it for roughly 89.00 avoid the dealership at all cost they can run 200.00-500.00 depending on if it is just the brakes pads or if it is the rotors and pads.

SOURCE: Brake Fluid for 2008 Avenger

it's DOT 4 or DOT 5 check with your manual and sometimes it's even in the fluid fill cap.

Testimonial: "Quick response, guided me in the right direction. Thanks!"

SOURCE: 2008 dodge avenger spark plug location and socket size.

• 2008+ Dodge Avenger 2.4L 4cyl.
• Remove plastic cover on top of engine, just pull on each corner for it is friction fit.
• Once removed you will see 4 black spark plug covers with one hex type screw holding each.
• Remove Hex screw and place aside, pull upward to remove plug boot from plug.
• To remove the plug, use a 5/8 socket with a 6" extension. Once plug has been turned out all the way and you cannot get the plug up and out of the hole, just press the plug boot back on the plug and pull it back up.
• Gap and replace 4 plugs with the same or equavalent type,. Drop plug down the hole and use socket to align and tighten until just snug, then torque to manufactures specifications.

SOURCE: i need a diagram of

There should be a diagram under your hood on the radiator support.

Hope this helps

SOURCE: I need a diagram for

the belt routing should be under the hood or on the upper rad support.some of these are on the timing cover in the form of a placard.if it is missing then draw the routing of the belt before you remove it making sure you draw all the pullys and how the belt goes around them.or you can get the routing from the parts store you bought the belt from.or the library has books that will show it for your car and motor