SOURCE: Generic Electronic module.
The gem is behind the dash in the center, behind the radio. It controls whipers, anti theft, 4x4, cargo lamp, insterment cluster, plus a few other things. Hope this helps.
SOURCE: Speedometer/odometer/cruise control isn't working.
It's your speed sensor at the transfercase on the drivers side i believe. Check the wire and clip to the sensor for any break or loose contacts.
Easy fix and is about a 30 min job to do with simple tools.
Un-clip the wire conntection, remove the retainer bolt and slide and sensor out. To install just do everything in reverse and add transmisson oil if needed.
Most of the time, it's going to be the sensor. Keep in mind that there are two sensor's so make sure it's the one on the output shaft at the transfercase. The other one is closer to the front of the transmission on the same side with is the input Volosity speed sensor.
If it was your ABS sensor, you ABS light would come on in your dash.
Good luck and hope this helps
SOURCE: Hi... We just bought a used 2004 nissan quest, the
Hello,
I just bought a 04 quest, and my radio would go out also. If you tap the console from the side, or you go over railroad track and it comes in and out, then there is a penny or some kind of change in the CD player. It also shorted out my DVD system. I went to the GV Electronics to have the dealership replace the DVD/TV, and they found a penny shorting out the Disc Player. (the previous owners kid must have put a penny in the CD hole.)
SOURCE: I need to replace my Nissan Quest 2007 in cabin micro filter
I'm going to send you exploded view of the glove box and the in cabin micro filter cover illustration. Remove the two upper screws on the glove box and carefully pry metal clips loose.
Disconnect glove box lamp electrical connector. Do not let glove box assembly hang from glove box lamp harness.
Remove three lower screws and remove damper clip from glove box door. Separate glove box housing and passenger instrument lower panel.
Remove three screws and remove in cabin micro filter cover.
Remove in cabin micro filters from front heater and cooling unit assembly.
Note When installing two new in cabin micro filters ensure that the filters are facing in the direction indicated by the direction arrow for the airflow. Direction arrow is printed on side of in cabin micro filters.
Install in cabin micro filter cover. Reinstall glove box.
Testimonial: "Finaly I found the air flow door with three screws and removed it. The filter will need replacement soon. It is been replaced one time at the dealer."
335 views
Usually answered in minutes!
×