It is located on the tires (near the brake rotors for the front tires and in the rear end housing for the rear tires). The job of the wheel speed sensor is to constantly monitor and report the rotational speed of each tire to the ABS control module.
SOURCE: Where are knock sensors in my 99 Lexus RX 300 ?
Hello there..They are in the back of the engine block about in the middle of the motor..There might be one in the front of the engine in the middle of the block but most are in back.Hope this helps you and have a great day..
I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589
SOURCE: burned out light bulb (# 9) in the manual, how do I change it on my 200 lexus rx 300?
Normal
0
false
false
false
MicrosoftInternetExplorer4
/* Style Definitions */
table.MsoNormalTable
{mso-style-name:"Table Normal";
mso-tstyle-rowband-size:0;
mso-tstyle-colband-size:0;
mso-style-noshow:yes;
mso-style-parent:"";
mso-padding-alt:0in 5.4pt 0in 5.4pt;
mso-para-margin:0in;
mso-para-margin-bottom:.0001pt;
mso-pagination:widow-orphan;
font-size:10.0pt;
font-family:"Times New Roman";
mso-fareast-font-family:"Times New Roman";
mso-ansi-language:#0400;
mso-fareast-language:#0400;
mso-bidi-language:#0400;}
Lift the hatch. The tall center light is located behind the
upper hatch inside panel. There are two
panels need to remove. One panel is on the right, the other on the left. To
remove the panels you have to use flat screw driver to pry out the panel in
several locations. (These panels are secured by several small metal clips.) Be
careful to collect all these clips and replace them on the back of the panel.
You will need these clips to replace the panel later on. After remove the panels,
you will be able to locate the screws on the tall center stop light assembly. Remove
those screws and cover. After replacing light bulb. Assemble everything in
reverse order. Remember, the metal clips have to set on the back of the two
panels not the car body.
SOURCE: I have a AWD 200 Lexus RX 300 and wanted to know
You don't need to change diff oils very often after first initial stage (usually about 25000km) After that about 80000km capacity should be in manual Probably about a quart each but just fill them up till oil starts running out cause the hole where you put the oil in is the level
SOURCE: 2000 Lexus RX 300 - VSC Light comes on and brake pulsation
you most likely have an "air gap" or "tone ring" problem with one of your sensors or tone rings. i would suggest letting a technician diagnos which problem it is, as it is a diagnosis that requires some experience.
SOURCE: HOW TO REPLACE PARK LIGHTS ON A LEXUS RX 300
YOU CAN BUY A HAYNES REPAIR MANUAL.IT HAS PHOTOS TO SHOW YOU AND TELL YOU HOW TO REPLACE PARK LIGHTS.
107 views
Usually answered in minutes!
×