Question about Jeep Cars & Trucks

Open Question

Does a 2004 jeep grand cherokee 4.7 4wd have tcu

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 2 Answers

SOURCE: 2004 Jeep Grand Cherokee - problem with power windows/locks

This seems to be the affects of a bad dinamo charging your battery . If you take a appart the dinamo you should fine a part called in mechanic terms "the bones" they look like 2 black magnets with a wire coming out of them . They are not expencive and you should not change your dinamo untill you try this first a car dinamo is very expencive .

Posted on Jan 21, 2009

Ad

Anonymous

  • 1 Answer

SOURCE: 2004 jeep gran cherokee front end clunk

you must replace and lube the front sway bar bushings,chrysler service bulletin calls it a squak, but can sound like a rubbing, a clunk etc the common factor is this is really noticeable the colder it gets outside

Posted on Mar 03, 2009

Mark Ridlen

  • 1 Answer

SOURCE: how to change fog light bulb on 2004 jeep grand cherokee

There's a small space behind inside fender. You can get your hand in there to grab and twist the back of the bulb to release it. You need a flashlight.

Posted on Mar 08, 2009

Anonymous

  • 1 Answer

SOURCE: windows and lock wont operate on a 2004 Jeep Grand Cherokee

I just had the same with mine, pull the rubber boot back on the drivers side front door and look for a severed wire, mine was black...simply spliced the wires back together and problem solved!

Posted on Mar 23, 2009

Richard Scordino

  • 6982 Answers

SOURCE: 2004 Jeep Grandcherokee - Transmission Maintenance

I'm going to guess since you didn't mention which fluid...Transmission?
First find out which unit you have (usually an id tag on it somewhere ) Then look up what kind and how much fluid in your owners manual (usually around four quarts...unit holds more but you can't remove it from the pan) Remove all pan bolts and lower pan. (some units have a drain plug, use it first if you have one ) you will see the filter attached to the valve body. remove it and install the new one, Make sure all gasket material is removed from pan and trans. Clean any metal etc from pan and internal magnet (there is always some in there but should not be a ton of it) Then put pan and gasket back. Make sure you can turn each fastener easily to make sure they are not cross threaded and only tighten them after they are all in there. Bolts do not have to be tightened down like they never should be removed again (snug then a little bit more)tighten in an X pattern not a circle.Replace about half of the fluid with car off, then put in remainder while running. Put your foot on the brake and shift to reverse then drive a few times then check fluid level.Low is bad, a tiny bit (less than half inch) over is OK.
Drive for a short ride, check again for leaks and re-tighten if any are found.
If trans was exceptionally dirty and yours has a drain plug, I recommend that you use a generic oil on the first change, then in a week, drain oil again and re-fill with good brand name stuff. and perhaps a bottle of lucas conditioner.
Good luck!

Posted on May 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have parking sensors on my 2006 jeep grand cherokee front and back. they do not work any more. the computer is telling me to service them. how? I do have two red lights on the displays and i can't...


When you put your jeep into reverse you will see the red lights. These will still work even when is says service parking assist system needs service. The problem is in your transmission control unit. This is a common problem in the Grand Cherokees. You will have two options here. You can take it to your Jeep dealership and ask them to flash the TCU. This may or may not work. The other option is they will have to replace the TCU. They run about $600.00. Hopefully if they flash the TCU it will work again. Good luck

Oct 03, 2011 | 2006 Jeep Grand Cherokee

2 Answers

Just purchased Jeep Grand Cherokee LTD TD 2001, looking for the handbook please?


Jeep Grand Cherokee 1999 at 2004 are called as WJ series.

Click in this link to download free 2004 Jeep Grand Cherokee WJ Owner's Manual.pdf (344 pages pdf file, 6.1 MB).

Hope helps (remember to rate this answer).

Apr 03, 2011 | 2001 Jeep Grand Cherokee

2 Answers

2004 jeep grand cherokee overheating


check the thermostat or your radiator might be stopped up

Apr 14, 2010 | 2004 Jeep Grand Cherokee

2 Answers

Needs new radiator, can you put a 2000 radiator in a 2004 jeep grand cherokee


I want to say yes compare the sizes and the water inlets and outlets to determine if it does. I am sure it will.

Sep 25, 2009 | 2004 Jeep Grand Cherokee

1 Answer

I am looking for a 1999 jeep grand cherokee owners manual to download


Jeep Grand Cherokee 1999-2004 also called WJ, about this model can check the information there: Jeep WJ 2000 Electrocnic Service Manual

Other details find in:
- Jeep Grand Cherokee WJ 2002 (all sections / spanish)
- WJ Jeep (several tips and DIY)

Good luck (remember rated this help).

Sep 02, 2009 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...