Question about Infiniti Cars & Trucks

1 Answer

I have 96 infiniti every time abs light comes on it dies out and won't restart any clue to what's going on

Posted by Chris on


1 Answer

Bogdan Odwazny

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Infiniti Master
  • 6,162 Answers

That is old, check wires near the wheel could be broken, any codes?

Posted on Nov 11, 2019


5 Related Answers


  • 4 Answers

SOURCE: abs light, engine light

I have the same car, same problem and I've been doing some research. It seems to be that the most common problem is a faulty ABS sensor that causes the car to go into "Limp Home Mode". Limp Home Mode is automatically initialized when the car senses that it has some sort of electrical or mechanical issue. This is most likely what your experiencing, because I, and many other X-type owners are as well. Good Luck.

Posted on Jul 27, 2008



  • 1 Answer

SOURCE: abs light/traction control light

You can check out what the trouble code is by pushing and holding the information button and the up arrow (right side of instrument cluster above the radio) until all the instrument clusters light. Press the information button (last) to enter test mode. I've had an error C1234, meaning Left rear wheel sensor fault. I found the problem to be a corroded connector under the chasis just under the rear left door about 2 feet in. I had to by-pass (replace 1 wire due to corrosion at the connector.

Posted on Sep 15, 2009


  • 7 Answers

SOURCE: brake pedal soft at times causing abs light to

Check your brake fluid level.

Posted on Feb 09, 2010


  • 15 Answers

SOURCE: ABS light comes on, traction light, and airbag

There should be a fuse between your battery and alt. If the fuse is blown, the current isnt getting back to the batt.

Something like this also happened to my brother in his Jetta, Im not saying its the same thing but his timing belt gave out.

Posted on Jan 28, 2011

raj somaiya

  • 5370 Answers

SOURCE: My clutch won't go down and won't go into any

ABS light coming on,For this get the Engine computer scanned.It can be error codes stored in computer.------------
For more details regarding this click the link below:-----
The ABS and Traction Control Lights stays ON dash of car?

And now for clutch not going in gears it can be faulty clutch issue or problem with clutch cable.This has to be inspected.For more detailed instructions regarding Peugeot clutch problem,click the link below:-----
Peugeot 307: Clutch will no go in gears?

This will help.

Posted on May 30, 2012

Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

96 infiniti g20 ABS light came on and car died

Have the fault codes read. Replace faulty items. Use only genuine items as non-genuine replacement are not always compatible with the OEM fitted CPU units If you needed a bigger battery then the autozone salesperson should have sold you the correct battery first time round.( try getting a refund on the first battery) Jump starting an efi vehicle incorrectly will do serious damage to the control module requiring a new ecu unit. Check what is staying on when you switch off including interior lights/ boot light

Jul 04, 2013 | Cars & Trucks

1 Answer

Security light flashing, car won't start for infiniti

Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module

Oct 18, 2012 | Infiniti M35 Cars & Trucks

1 Answer

96 Acura TL ABS light comes on and off and causes the engine light to click on at a red light. Engine acts like it won't to cut out when the ABS light goes on and off. Whats wrong? FYI, ABS ligh

Any time you get any dash light ,you have the car checked
for codes within a day or two,not a year

You have had some type of failed system component
or issue for a year.

Sep 17, 2012 | 1996 Acura TL Series

1 Answer

Brake and slip lights won't go out,brakes replaced fluid full any clues,the dealer ship wanted to replace the master cyclinder

Probably the ABS module. But did the lights come on straight after the brake work? You should first look at the abs sensors at each wheel espaecially the wheels the brake work was done on & make sure they are bolted in their slot & there is a notched wheel for the sensor to pick up on. You can test the sensors individualy with a multi meter. Jack & supprt car with stands, remove wheels for easy access, unplg the sensor at the nearest plug, set multimeter to 12VAC 12V~ and put 1 probe to each wire, spin the wheel & the multimeter will read a voltage. Repeat with all sensors at approx the same speed & you should get similar readings. Let me know the utcome of these tests.

Jun 22, 2012 | 2006 Nissan Titan

1 Answer

96 Dodge Caravan ABS Battery lights stays on, radio dies, gauges drop, then restores Advice needed? Hi, I'm a bit new, so I hope you will forgive my lack of knowledge here. I have a 96 Dodge Caravan Sport...

Sounds like the BCM (body Control Module), although it could be a bad battery or alternator. Since the van keeps running ok, I'd tend towards the BCM.

Since you lose speedo and such, it's a bit dangerous to let it go too long. ;>

You can also buy a cheap dollar store light that plugs into your cigarette lighter. Make sure you can see it, but it doesn't blind you. If the light stays at about the same brightness, or gets a _little_ brighter when the gremlins attack, it's probably NOT the battery or alternator. yes, it cheesy and cheap, but I _like_ cheap troubleshooting.

Sep 01, 2010 | 1996 Dodge Caravan

1 Answer

Abs light stays on

Need to hook it up the an ABS scanner to get a clue to what's going on here. most likely it will be a deffective wheel speed sensor. does the abs come on the first few times you apply the brake?

Jun 25, 2009 | 2002 Chevrolet Tahoe

1 Answer

Car dies immediately after starting


May 17, 2009 | 2005 Infiniti G35

Not finding what you are looking for?

Open Questions:

Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Infiniti Experts


Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14852 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6523 Answers

Are you an Infiniti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides