run fault codes to check for accelerator position sensor problems . Check for vacuum leaks. If cable accelerator then check that the return spring on the end of the cable is attached and not missing.
hangon. your leaving something out. myguess is you had the ebrake pulled so the car didn't roll when it was in gear. and now the car wont move at all or what? you left alot of important info out. if it is running and wont move at any point you broke something in the trany or a driveshaft. you should not be able to shift the trany into any gear if the engine is running. the clutch is turning and unless the clutch is disengaged you wont be able to shift. knowing that i am guessing you broke it good and need a new trany
Simply press your left foot on the clutch pedal, and move the stick shift to the desired gear. When doing so, please go off the gas pedal with your right foot.
Your problem looks like there is no 4th gear
One thing you could do is :
1. Drive your car at a steady speed and cruising while your right foot is on the gas pedal with your left foot just touch a little bit the brake pedal just to release the brake switch and look the RPM should drop of 300 to 500 rpm in 3th gear. If so, you have the TCC (Torque Converter Clutch) applied next.
2. Retrieve the engine code with a scanner to see if there is any faulty transmission or engine code.
3. If you have code register than you have to solve the code first.
4. After the fix is done erase code so the PCM (Powertrain Control Module)will reset to normal.
5. Test drive to see if your problem is solved.
P.S.: Transmission fluid is very important. Do a transmission flush if you doubt.
×