You should have oil cooler lines on the filter adapter and the sender is there it screws into the adapter and has one contact inside the plug go to rockauto.Com and look up your vehicle and then the part in electrical switch and relay it may just be shorting out from the oil filter leaking and cleaning and a new oil filter may stop it from lighting up but maybe not good luck stephen
SOURCE: Location of the Oil Pressure Sending Unit
On the drivers front of engine block below the cylinder head & gasket . Slightly behind waterpump.
SOURCE: oil pressure sending unit location
On the 4.0L they put it on the passenger side rear of the engine. On the 4.7L they put ot on the lower left drivers side above the oil filter.
SOURCE: location of the oil pressure sending unit 1994
The oil pressure sender is above or below the oil filter, threaded into the side of the engine block.
Hope this helps you.
SOURCE: diagram for the location of the oil pressure
the oil sending unit is in the rear of the motor center right as you face the motor.You almost have to climb up on the motor to see it because it is down on the block.If you remember where the distributor used to be in the rear.The sending unit is just to the right as you face the motor.Good luck.
SOURCE: Trying to find location of oil pressure sending
Your best bet is to get the Haynes Repair manual on your vehicle to locate this and make this repair.
622 views
Usually answered in minutes!
×