Question about Hyundai Cars & Trucks
Posted by Anonymous on
SOURCE: hyundai getz
if the speedo still works then it will need a spedo unit if the speedo doesn't work it is either the cable or the gear in the trans to check the cable unthread from trans and attach a drill to the cable innereds spin the drill if the speedo does not move replace the speedo cable
Posted on Oct 18, 2008
On a 2.7L it is located above and to the right of the starter. You will have remove the starter heat shield to gain access to it.
Posted on Jun 25, 2009
if you changed the timing belt and balancer belt. you may be 1 tooth off. will miss like a champ if the belt was changed
Posted on Aug 07, 2009
The sensor is located on the left hand rear side of the block (near the bell housing). It is held in place by a 10mm bolt. It's to the right of the exhaust manifold (LH - radiator side) on the V6. Once you purchase the new sensor you'll be able to identify it on the engine. The connector to this sensor is located in the illustration.
A word to the wise... replace the O2 snsr as well.
Posted on Oct 04, 2009
Posted on Oct 09, 2011
Tips for a great answer:
Apr 06, 2016 | 2007 Hyundai Getz 1.6
Jan 01, 2015 | Hyundai Cars & Trucks
Dec 07, 2014 | Hyundai Cars & Trucks
Aug 17, 2014 | 2008 Hyundai Accent
Jun 24, 2012 | 2007 Hyundai Getz 1.4
Apr 08, 2012 | 2007 Hyundai Getz 1.4
71 people viewed this question
Usually answered in minutes!